Cart 2 india

Specification
Brand : Hard-to-Find Fastener
BulletPoint1 : Diameter: 3/8"
BulletPoint2 : Length: 3-3/4 inches
BulletPoint3 : Material: Stainless Steel
BulletPoint4 : Drill Size: 3/8 inches
BulletPoint5 : Type: Wedge Anchor
BulletPoint6 : ⚠ Important: the nut and washer must be taken off the anchor prior to using the installation tool. Failure to do so will result in damage to the tool that will not be covered by warranty.
Color : Silver
CompatibleGrooveDiameter : 0.25 inches
ExteriorFinish : Zinc
ExteriorFinish1 : Stainless Steel
ExteriorFinish2 : Zinc
ExternallyAssignedProductIdentifier1 : 014973180249
ExternallyAssignedProductIdentifier2 : 738287503838
ExternallyAssignedProductIdentifier3 : 0014973180249
ExternallyAssignedProductIdentifier4 : 0738287503838
ExternallyAssignedProductIdentifier5 : 00738287503838
FinishType : Zinc Plating or Hot-Dip Galvanized
GradeRating : industrial
IncludedComponents : Anchors(25)^Hex Nuts(25)^Flat Washers(25)
ItemDisplayDimensions_Length : 3.38 inches
ItemDisplayWeight : 3.2 pounds
ItemName : Hard-to-Find Fastener 014973180249 Wedge Anchors, 3/8 x 3-3/4, Piece-25
ItemPackageDimensions_Height : 22.8 centimeters
ItemPackageDimensions_Length : 3.3 centimeters
ItemPackageDimensions_Width : 14.4 centimeters
ItemPackageQuantity : 1
ItemShape : Block,wedge
ItemTypeKeyword : wedge-anchors
Manufacturer : Midwest Fastener Corp
ManufacturerGrade : Grade 2
Material : Stainless Steel
MeasurementSystem : Imperial
MetalType : Carbon Steel
ModelNumber : 14973180249
NumberOfItems : 25
NumberOfPieces : 10
PackageLevel : unit
PartNumber : WASS-051-25
ProductDescription : Wedge Anchors are extremely popular and are one of the strongest anchors for hold strength. The most common anchors are used for medium duty hanging by all trades. Our Wedge Anchor Setting Tool provides a revolutionary patented system for installing wedge type concrete anchors. This system is the choice of professional contractors in all trades- coast to coast. It provides a safe and efficient method for installing anchors overhead, in walls, or in floors. Our setting tools significantly reduce the risk of damage to the anchor threads during installation. To install a wedge anchor simply drill a hole that is the same size diameter as the anchor and place it into the hole. After placing the material being held to the concrete on the exposed portion, place the washer and thread the fastener onto the anchor. As the nut is tightened against the washer, it will begin pulling the anchor up. This will result in the wedge skirt catching the concrete and expanding and digging into the concrete as the anchor is pulled.
ProductSiteLaunchDate : 2010-06-10T20:42:25.000-00:00
Size : 3/8 x 3-3/4"
Style : tie Wire
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 25
UnspscCode : 31160000