Cart 2 india

Specification
Brand : CONFAST
BulletPoint1 : MADE FROM 304 STAINLESS STEEL - Can be used in wet, submerged environments and will not rust
BulletPoint2 : WIDE RANGE OF SIZES - Insures proper fastener for best results
BulletPoint3 : PACKAGED WITH NUTS AND WASHERS - Fast, quick, complete installation
BulletPoint4 : HOLE SIZE IS ANCHOR SIZE - Simplicity and ease of installation
ExteriorFinish : Zinc
ItemName : CONFAST American Made 7/8" x 12" 316 Stainless Steel Wedge Anchor (5 per Box)
ItemPackageDimensions_Height : 3.5 inches
ItemPackageDimensions_Length : 12.5 inches
ItemPackageDimensions_Width : 4.5 inches
ItemPackageQuantity : 1
ItemShape : Block,wedge
ItemTypeKeyword : wedge-anchors
Manufacturer : CONFAST
ManufacturerGrade : Grade 2
Material : Stainless Steel 316 (A4)
MaximumShearStrength : 18250
NumberOfItems : 5
NumberOfPieces : 5
PartNumber : TSS-3167812
ProductDescription : Applications
The anchor is made from 316 Stainless Steel and meets the Buy America Act (BAA). This anchor is designed for use in Concrete only, and should never be used in block or brick base material.

Environment
The anchor is designed for use in a Submerged/Chemicals environment.

Hole Diameter/Bit Diameter
The anchor requires a 7/8" hole to be drilled in the base material (Concrete only). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 7/8".

Length Anchor
The length of the anchor is 12"

Thread Length
The length of the threads on the anchor is 2-1/2" in length.

Minimum Embedment
The minimum anchor embedment into the concrete is 3-7/8". Therefore, the anchor must be installed so that a minimum of 3-7/8" of the anchor is embedded into the concrete.

Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 7". This will ensure that the minimum embedment of 3-7/8" will be met.

Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 7/8" diameter anchor requires the hole in the fixture to be 1-1/8".

Spacing between Anchors
Each anchor must be spaced a minimum distance of 8-3/4" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 4-3/8" from an unsupported edge of the concrete.
ProductSiteLaunchDate : 2017-06-13T11:51:42.970Z
Size : One Size
UnspscCode : 31160000