Cart 2 india

Specification
Brand : HFBTE
BulletPoint1 : Suitable for Pigment Coating Paint Finishes Oil lacquer Paint Ink Varnishes Syrup Etc
BulletPoint2 : Cup volume: 100 + 1ml
BulletPoint3 : Nozzle diameter:4mm+0.02mm
BulletPoint4 : Ideal Measuring Range 96 To 683 cSt;Flow time (sec): 20-110sec
BulletPoint5 : Anodic alumina cup body;Internally polished stainless steel nozzle
Capacity : 100 milliliters
CareInstructions : no
Color : Silver
IncludedComponents : din 4 viscosity cup
ItemName : HFBTE Din Cup Din 4 Viscosity Cup DIN Immersion Flow Cup For Paints Inks Lacquers And Other Liquids With Pore Size 4mm±0.02mm Ideal Measuring Range 96 To 683 cSt Cup Volume 100ml
ItemPackageDimensions_Height : 0.3 inches
ItemPackageDimensions_Length : 0.7 inches
ItemPackageDimensions_Width : 0.2 inches
ItemTypeKeyword : science-lab-viscometers
Manufacturer : HFBTE
Material : Aluminum
ModelName : 2024112102dara
ModelNumber : 2024112102dara
NumberOfItems : 1
PartNumber : 2024112102dara
ProductDescription : HFBTE Din Flow Cup Din Viscosity Cup Din Cup With Pore Size 4mm±0.02mm Ideal Measuring Range 96 To 683 cSt Cup Volume 100ml For Paints Inks Lacquers And Other Liquids

Introduction：
♦The DIN cup is according to the German Standardization Committee (DIN53211 Deutsches lnstitut fur Normung) specified in the production, used for the determination of ink, paint, paint viscosity more convenient.
♦It is composed of a bottom viscometer with small holes, and the capacity is about 100ml high quality aluminum cup refining.
♦DIN cup through the determination of aluminum cup a certain capacity of the sample from the bottom of the hole out of the time required to sample the measured viscosity.

Technical Parameters
♦Suitable for Pigment Coating Paint Finishes Oil lacquer Paint Ink Varnishes Syrup Etc
♦cup volume:100 + 1ml
♦nozzle diameter:4mm+0.02mm
♦suitable for measuring range:100-500% Storck/Ideal Measuring Range 96 To 683 cSt
♦anodic alumina cup body
♦internally polished stainless steel nozzle

Operation method:
1.before use should choose appropriate solvent to clean the inner wall of the cup body (Note:please pay special attention to cleaning holes,the cup body can spill into soft rope,repeated pumping in the outflow hole;then pull) in air drying or dry cold,residue adhesion past measurement in the cup or outflow port allow.
2.apply proper cup numbers so that the flow time is controlled between 20~100 seconds(see technical parameters)
3.the solution mixing and filtering in the screen is not less than 567 holes/cm,and the sample and out cup temperature adjustment to the(23 + 0.5C) or another agreed upon temperature.
4.adjust the viscosity cup bracket(need to be further ordered)the horizontal bolts of the platform to make the horizontal bubbles on the top center
5.open or push the baffle of the finger,the sample
ProductSiteLaunchDate : 2024-11-20T08:00:00.000Z
Size : small
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnspscCode : 52151600