Cart 2 india

Specification
Brand : Generic
BulletPoint1 : Replace your worn tiller tines with these High Quality Boron Steel Italian made aftermarket replacement tines compatible with HawkLine 48", 60" and 72" width tillers
BulletPoint2 : This listing is for one (1) left hand and one (1) right hand tines that will fit the all of the Hawkline Tiller models.
BulletPoint3 : These tines are 5/16" thick instead of the 1/4" thick original tines and 2-1/2" wide at the cutting edge. They have 9/16" bolt holes that are spaced 1-9/16" on center.
BulletPoint4 : OEM part numbers are used only for identification, it's high-quality aftermarket parts.
BulletPoint5 : We are always ready to help you in any situation, your purchase is fully guaranteed by our store
CompatibleWithVehicleType : All Terrain Vehicle
ExternallyAssignedProductIdentifier : 7403464144496
ExternallyAssignedProductIdentifier1 : 0753512911219
ExternallyAssignedProductIdentifier2 : 753512911219
FuelType : Bronze
ItemName : 1 Each Left and Right Tiller Tine Compatible with HawkLine Tillers
ItemPackageDimensions_Height : 12.5 inches
ItemPackageDimensions_Length : 9.5 inches
ItemPackageDimensions_Width : 1 inches
ItemPackageQuantity : 2
ItemTypeKeyword : power-tillers
Manufacturer : AMA
Material : Alloy Steel
NumberOfItems : 36
OperationMode : Manual
PartNumber : HL-L- HL-RX1
PowerSourceType : manual
ProductDescription : Replace your worn tiller tines with these High Quality Boron Steel Italian made aftermarket replacement tines compatible with HawkLine 48", 60" and 72" width tillers. This listing is for one (1) left hand and one (1) right hand tines that will fit the all of the Hawkline Tiller models. This listing is for a total of two (2) tines. Please check tine dimensions below to make sure of fitment. Adjust your purchase quantities to meet your replacement tine needs, we also have full sets of these tines listed at discounted pricing These tines are 5/16" thick instead of the 1/4" thick original tines and 2-1/2" wide at the cutting edge. They have 9/16" bolt holes that are spaced 1-9/16" on center. These tines measure 7-1/2" from the tip of the cutting edge to the top of the tine measured straight across the tine not around the bend. We sell replacement tines and parts for most brands of Roto Cultivators, if you don't see them listed here please feel free to give me a call. Part Numbers: HL-L & HL-R We stock a wide variety of replacement parts for Agricultural Equipment please contact us if you have any questions or if you would like more information.
ProductSiteLaunchDate : 2022-01-15T08:18:51.086Z