Dixell XR60CX-5N1C1 230V/50-60Hz Digital Microprocessor Thermostat Controller Defrost Compressor Fan for Medium Low Temperature Ventilated Refrigerating Units(with 2 NTC Probe Inputs)

Imported from USA | Ships in 10 working days

5% instant discount on non COD

1

₹ 22300/-

The price at cart2india.com is inclusive of custom duties, GST, freight forwarding and other charges.

Free Shipping across India. Powered by BlueDart

Product Information


Specification
AgeRangeDescription : adult
Brand : YZSSKU
BulletPoint : Pushbutton Switches
BulletPoint1 : COMPRESSOR:The regulation is performed according to the temperature measured by the thermostat probe with a positive differential from the set point: if the temperature increases and reaches set point plus differential the compressor is started and then turned off when the temperature reaches the set point value again. In case of fault in the thermostat probe the start and stop of the compressor are timed through parameters “COn” and “COF“.
BulletPoint2 : DEFROST:Two defrost modes are available through the “tdF” parameter: defrost through electrical heater (tdF= EL) and hot gas defrost (tdF = in). Other parameters are used to control the interval between defrost cycles (IdF), its maximum length (MdF) and two defrost modes: timed or controlled by the evaporator’s probe (P2P).At the end of defrost dripping time is started, its length is set in the FSt parameter. With FSt =0 the dripping time is disabled.
BulletPoint3 : CONTROL OF EVAPORATOR FANS:The fan control mode is selected by means of the “FnC” parameter: FnC = C_n: fans will switch ON and OFF with the compressor and not run during defrost FnC = o_n fans will run even if the compressor is off, and not run during defrost; After defrost, there is a timed fan delay allowing for drip time, set by means of the “Fnd” parameter. FnC = C_Y fans will switch ON and OFF with the compressor and run during defrost;
BulletPoint4 : An additional parameter “FSt” provides the setting of temperature, detected by the evaporator probe, above which the fans are always OFF. This is used to make sure circulation of air only if his temperature is lower than set in “FSt”.
BulletPoint5 : Forced activation of fans:This function managed by the Fct parameter is designed to avoid short cycles of fans, that could happen when the controller is switched on or after a defrost, when the room air warms the evaporator. Functioning: if the difference of temperature between the evaporator and the room probes is more than the value of the Fct parameter, the fans are switched on. With Fct=0 the function is disabled.
Color : 50 Normal Closed
Department : Unisex Adult
ExternallyAssignedProductIdentifier : 7341562512079
ExternallyAssignedProductIdentifier1 : 0765551426487
ExternallyAssignedProductIdentifier2 : 765551426487
GpsrSafetyAttestation : 1
IncludedComponents : 1
ItemName : Dixell XR60CX-5N1C1 230V/50-60Hz Digital Microprocessor Thermostat Controller Defrost Compressor Fan for Medium Low Temperature Ventilated Refrigerating Units(with 2 NTC Probe Inputs)
ItemPackageDimensions_Height : 10 centimeters
ItemPackageDimensions_Length : 10 centimeters
ItemPackageDimensions_Width : 10 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : thermostat-controllers
Manufacturer : YZSSKU
Material : Copper
ModelName : ATIUHIFR
ModelNumber : ATIUHIFR
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : Dixell-Jason2024081000008
ProductDescription : Model XR60CX,format 32 x 74 mm,is microprocessor based controller,suitable for applications on medium or low temperature ventilated refrigerating units.It has three relay outputs to control compressor, fan, and defrost,which can be either electrical or reverse cycle (hot gas).It is also provided with 2 NTC or PTC probe inputs,the first one for temperature control, the second one,to be located onto the evaporator,to control the defrost termination temperature and to managed the fan.The digital input can operate as fourth temperature probe.
The HOT KEY output allows to connect the unit,by means of the external module XJ485-CX, to a network line ModBUS-RTU compatible such as the Dixell monitoring units of X-WEB family.It allows to program the controller by means the HOT KEY programming keyboard.The instrument is fully configurable through special parameters that can be easily programmed through the keyboard.

Specification

Housing: self extinguishing ABS.
Case: XR60CX frontal 32x74 mm,depth 60mm;
Mounting: XR60CX panel mounting in a 71x29mm panel cut-out
Protection: IP20.
Connections:Screw terminal block ± 2,5 mm2 wiring.
Power supply:according to the model:230Vac ±10% 50/60Hz
Power absorption:3VA max
Display:3 digits,red LED,14,2 mm high; Inputs: Up to 4 NTC or PTC probes.
Digital input:free voltage contact
Relay outputs:compressor SPST 8(3) A,250Vac;or 20(8)A 250Vac
Data storing: on the non-volatile memory (EEPROM).
Kind of action: 1B; Pollution grade: 2;Software class: A.

Package Include

1 X Dixell XR60CX Digital Thermostat Controller with 2 NTC Probe Inputs
ProductSiteLaunchDate : 2024-08-10T10:26:05.238Z
Size : One Size
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 26000000
Voltage : 230 volts

Questions & Answers

Have a question? Ask experts

?
No question found

Ratings & Review

Rating Breakdown (average)

5*
0
4*
0
3*
0
2*
0
1*
0

No reviews found.

Have an opinion on this page? Let's hear it.