Cart 2 india

Specification
AgeRangeDescription : Adult
Brand : DGT Tattoo Supply
BulletPoint : Model: 2610 flat motor
BulletPoint1 : WX3+ with the ring switch on/off ,Voltage Output: 6, 7, 8 ,9, 11V, .Charging Voltage DC5V/1A, Input: TYPE-C
BulletPoint2 : Battery Capacity: 1450MAH, 4.Dual charge and discharge protection (Battery built-in over-surge protection, control board with short circuit over-surge over-discharge protection more safe.)
BulletPoint3 : Press power button for 2 seconds to turn on machine, 6.Press up/down button to change the voltage, voltage goes in a cycle from: 5V-12V, Pass the up/down button for 3 seconds for the jump start (H) (L) seting
BulletPoint4 : Once machine is turned on, there will be a quick jump start at 10V, after 0.2 seconds machine will automatically resume to the last used voltage
BulletPoint5 : This product does not allow charging and running the machine at the same time, If short-circuit protection occurs during use, just plug into the charger and it will activate automatically
Color : Black
ExternallyAssignedProductIdentifier1 : 793811107425
ExternallyAssignedProductIdentifier2 : 0793811107425
ItemName : DGT WX-3Plus Tattoo Machine Battery with Ring on/off switch RCA CONNECTOR
ItemPackageDimensions_Height : 2.5 inches
ItemPackageDimensions_Length : 9 inches
ItemPackageDimensions_Width : 2.5 inches
ItemTypeKeyword : tattoo-machines
Manufacturer : DGT Tattoo Supply
Material : Plastic
ModelNumber : WX-3Plus
NumberOfItems : 1
PartNumber : TM99-1075-06RCA
Pattern : Solid
ProductDescription : 1.WX3+ with the ring switch on/off Voltage Output: 6, 7, 8 ,9, 11V 2.Charging Voltage DC5V/1A, Input: TYPE-C 3.Battery Capacity: 1450MAH 4.Dual charge and discharge protection (Battery built-in over-surge protection, control board with short circuit over-surge over-discharge protection more safe.) 5.Press power button for 2 seconds to turn on machine, 6.Press up/down button to change the voltage, voltage goes in a cycle from: 5V-12V, Pass the up/down button for 3 seconds for the jump start. 7.Once machine is turned on, there will be a quick start at 10V, after 0.2 seconds machine will automatically resume to the last used voltage. 8.During sleep mode, Battery display will show after 2 seconds of using the power button. While machine is in sleep mode, the light indicator 1-5 will show the remaining percentage of battery left 20%-100%. Press the power button again, it will resume to Voltage adjustment. 9.When in charging mode, light indicator will flash to display charging. Solid light will indicate charging is complete and enters “protection” mode. 10.The battery has a charging current limit, the battery capacity is 1450MAH, approximate charge time is 3.5 hours for full charge. Work time varies depending on the Voltage level. (Voltage output below 8V can last about 8 hours.) 11.This product is mainly used for rotary tattoo machine, please do not use with coil tattoo machine. 12.This product does not allow charging and running the machine at the same time. 13.If short-circuit protection occurs during use, just plug into the charger and it will activate automatically.
ProductSiteLaunchDate : 2019-12-10T08:00:00.000Z
Speed : 9000 rpm
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 53131800
WaterResistanceLevel : water_resistant