Cart 2 india

Specification
Brand : Yosoo
BulletPoint1 : [Clear Display] 0.56-Inch led screen shows green rpm readings with precision.
BulletPoint2 : [High Speed] Capable of measuring revolution speed up to 9999rpm.
BulletPoint3 : [Precise Measurement] Equipped with 3-wire npn hall proximity sensor for accurate results.
BulletPoint4 : [Quick Response] Highly precise and for stable performance.
BulletPoint5 : [Wide Supply Voltage] Operates on 8-24v suitable for various rpm measurement applications.
ItemName : Green LED 4 Digit Motor Tachometer RPM Speed Gauge NPN Hall Proximity Sensor for RPM Measurement (Speedometer)
ItemPackageDimensions_Height : 3 centimeters
ItemPackageDimensions_Length : 12 centimeters
ItemPackageDimensions_Width : 10 centimeters
ItemTypeKeyword : industrial-tachometers
Manufacturer : Yosoo
ModelName : Yosoo35b6sgg1wd-11
ModelNumber : Yosoo35b6sgg1wd-11
PartNumber : Yosoo35b6sgg1wd-11
ProductDescription : [Clear Display] 0.56-Inch led screen shows green rpm readings with precision.
[High Speed] Capable of measuring revolution speed up to 9999rpm.
[Precise Measurement] Equipped with 3-wire npn hall proximity sensor for accurate results.
[Quick Response] Highly precise and for stable performance.
[Wide Supply Voltage] Operates on 8-24v suitable for various rpm measurement applications.

Spec:

Item Type: Tachometer
Display: 0.56inch green LED, 4 digit reading
Measuring Range: 10-9999rpm
Measuring Accuracy: ±0.1%, reading±1digit
Display Refresh Rate: >3 times/sec
Overrange Display: Display 1 or -1 in the first digit position, none in the last three digit positions
Hall Proximity Switch Type: NPN NO
Tachometer Size: 79x26x43mm / 3.11x1.02x1.69in



Package List:
1 x LED Tachometer
1 x Hall Proximity Switch
1 x Round Magnet
1 x Cable


Note:
1. Connect the plug correctly according to the wiring diagram.
2. The Hall switch is an NPN normally open type, and the detection distance of the Hall switch needs to be within 10 mm. The Hall switch is installed with a diameter of 12 mm and a wire length of 1m or less.
3. Avoid strong electromagnetic interference, the measurement wire is best to use shielded wire or twisted pair wire.
4. The counter and the clear input switch or circuit should be as close as possible to the terminals of the counter to make the line as short as possible.
5. Avoid the same tube or stranded wiring with strong electric wires or power wires to avoid unnecessary interference. If necessary, please use shielded wires, and the shielding layer is connected to the counting terminal +.
6. It is not recommended to use mechanical switches or micro switches, because their life is relatively short, it is easy to miscount after a long time;
ProductSiteLaunchDate : 2024-10-15T03:27:12.510Z
Size : speedometer
UnspscCode : 41110000