Cart 2 india

Specification
Brand : Generic
BulletPoint : Elevator Tacho speed encoder motor KOLP017 RE.0444L1B0.06CA KM276027 TACHOGENERATOR generator RE.O444 L1B 0.06 CA FOR KONE
BulletPoint1 : High precision, fast response, stable and reliable.
BulletPoint2 : Speed ​​measurement up to 9999 rpm.
BulletPoint3 : 8-24V wide supply voltage, suitable for various applications of speed measurement.
BulletPoint4 : Comes with a 3-wire NPN Hall proximity switch sensor.
BulletPoint5 : The 0.56-inch 4-digit LED screen clearly displays RPM values ​​in green.
ExternallyAssignedProductIdentifier : 7644990390715
ItemName : Green 4 Digit LED Engine Tachometer Tachometer NPN Hall Proximity Switch Sensor (Speedometer)
ItemPackageDimensions_Height : 3 centimeters
ItemPackageDimensions_Length : 12 centimeters
ItemPackageDimensions_Width : 10 centimeters
ItemTypeKeyword : industrial-tachometers
Manufacturer : Generic
ModelName : YWBL-WHb06i1peqmk
ModelNumber : Genericp652gf3vey-11
PartNumber : Genericp652gf3vey-11
ProductDescription : 1. The 0.56 inch 4-digit LED screen clearly shows the speed values ​​in green.
2. Comes with a 3-wire NPN Hall proximity switch sensor.
3. Speed ​​measurement up to 9999 rpm.
4. High precision, fast response, stable and reliable.
5. 8-24V wide supply voltage, suitable for various applications of speed measurement.

Specification:
Item Type: Tachometer
Operating voltage: DC 8-24V, 40mA
Display: 0.56 inch green LED, 4 digit display
Measuring range: 10-9999 rpm
Measuring accuracy: ±0.1%, display ±1 digit
Display refresh rate: >3 times/sec.
Exceedance display: Display “1” or “-1” in the first digit, none in the last three digits
Hall proximity switch type: NPN NO
Speedometer size: 79 x 26 x 43mm / 3.11 x 1.0 02x1.69in

Packing list:
1 x LED Tachometer
1 x Hall Proximity Switch
1 x Round Magnet
1 x Cable

A notice:
1. Connect the connector correctly according to the circuit diagram.
2. The Hall switch is NPN normally open type and the detection distance of the Hall switch must be within 10mm. The Hall switch is installed with a diameter of 12mm and a cable length of 1m or less.
3. Avoid strong electromagnetic interference. It is best to use a shielded cable or a twisted pair cable as a measuring cable.
4. The counter and the input switch or circuit for the clear should be as close as possible to the terminals of the counter to make the line as short as possible.
5. Avoid the same pipe or stranded wiring with strong electrical cables or power cables to avoid unnecessary interference. If necessary, please use shielded cables and connect the shielding layer to the “+” counting terminal.
6. It is not recommended to use mechanical switches
ProductSiteLaunchDate : 2024-09-01T18:05:24.091Z
Size : speedometer
UnspscCode : 41110000