Cart 2 india

Specification
Brand : SÜA
BulletPoint1 : All-position, mild steel electrode for welding light to medium-gauge steel. Common uses include tack welding on thin sheet metal such as galvanized sheets, automobile bodies, metal furniture, window frames, fences, storage tanks, farm equipment and iron grills
BulletPoint2 : Excellent operating characteristics when using small diameter electrodes to weld thin sheet metal using lower open-circuit AC voltage
BulletPoint3 : One of the easiest electrodes to use because of its easy slag control in vertical down welding, its wide operating range and restrike capabilities
BulletPoint4 : This electrode has a soft, steady and quiet arc that produces very little smoke or spatter
BulletPoint5 : Select your Electrode Diameter and Package Quantity from the Options - Check Picture #3 for Welding Parameters.
Color : Multicolored
ExternallyAssignedProductIdentifier : 00840338563873
ItemDisplayWeight : 44 pounds
ItemName : E6013 - General Purpose/Mild Steel - Welding Electrode/Rod - 12" x 3/32" (44 LB)
ItemTypeKeyword : arc-welding-stick-electrodes
Manufacturer : MUNDAKA TECHNOLOGIES INC
Material : Iron
ModelNumber : E6013
PartNumber : SWT-6013E12x332x44
ProductDescription : Instructions: Clean the weld zone of contaminants as well as possible. A small AC machine or DC machine (electrode + reverse polarity or – straight polarity) can both be used! AC will prevent arc blow, DC+ reverse polarity produces deeper penetrating welds on medium gauge steels and DC- straight polarity on thinner or light gauge steels. Set amperage to the proper range as listed on the product recommended amperage chart. Maintain a short arc length and hold the electrode at a 15° angle and use a slight back and forth whipping motion. If overhead welding, use a straight circular motion. For vertical-down welding, choose amperage in the upper end of the recommended range and use stringer beads or a slight weaving technique keeping the weld puddle in place by pointing the electrode up into the puddle. For vertical-up welding, use amperage settings in the lower end of the recommended range and use the shelf or step method adding layer on top of layer. Do not use whipping motion. Allow the part to air-cool and remove slag with a chipping hammer and brush to a nice finish.
ProductSiteLaunchDate : 2023-10-17T18:39:46.370Z
Size : 3/32" - (44 Lb)
UnitCount : 1
UnspscCode : 23271800