Cart 2 india

Specification
Brand : YG-1
BulletPoint1 : High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance
BulletPoint2 : Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications
BulletPoint3 : Weldon shanks feature a round shank with one of more flats machined into the side for easy indexing and alignment
BulletPoint4 : When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging
BulletPoint5 : Center cutting allows these end mills to drill into the part for the beginning of a slot
CutType : General Purpose
EndCutType : Center
FinishType : Unfinished
ItemName : YG-1 E1039 High Speed Steel (HSS) Square Nose End Mill, Weldon Shank, Uncoated (Bright) Finish, 30 Deg Helix, 4 Flutes, 4.5" Overall Length, 1.5" Cutting Diameter, 1.25" Shank Diameter
ItemPackageDimensions_Height : 4.572 centimeters
ItemPackageDimensions_Length : 13.716 centimeters
ItemPackageDimensions_Width : 5.08 centimeters
ItemPackageQuantity : 1
ItemShape : Square
ItemTypeKeyword : square-nose-end-mills
Manufacturer : YG-1 Tool Company
Material : High Speed Steel (HSS)
ModelNumber : 07211
NumberOfFlutes : 4
NumberOfItems : 1
PartNumber : 07211
ProductDescription : Material: All tapered end mills are produced from a premium grade of super submicrograin carbide to give you the maximum hardness and toughness. This means longer cutting life with less breakage * Grinding: All flutes are hollow ground with double clearance angles. The flute face is also hollow ground and polished to assure free cutting actions with minimum of heat generation. All tools have end cutting teeth. Special grinding procedures and equipment assures a high degree on concentricity between shank and cutting flutes * Tolerances: Taper angles constant to +/- .001" per inch of flute length. Tip diameter tolerances are held at +/- .002". Shank diameter tolerances are -.0002 to -.0005".
ProductSiteLaunchDate : 2012-05-05T08:00:01.000Z
Size : 1-1/2 inches
SupplierDeclaredDgHzRegulation : unknown
ToleranceHeld : +0.0010/-0.0000 inches
UnitCount : 1
UnspscCode : 27112803