Cart 2 india

Specification
Brand : SHONFYVS
BulletPoint1 :
BulletPoint2 :
BulletPoint3 :
BulletPoint4 :
BulletPoint5 :
Color : 12v
ExternallyAssignedProductIdentifier : 7642780252915
ExternallyAssignedProductIdentifier1 : 0756804398118
ExternallyAssignedProductIdentifier2 : 756804398118
IncludedComponents : One host power cable Foot switch Workpiece clip Tungsten needle Torch needle holder Instruction manual
ItemName : Jewelry Spot Welding Machine Electric Welding Machine 110v Jewelry Pul-se Argon Spot Welder Jewelry Soldering Welder Adjustable pul-se spot welding machine for Gold Silver Platinum
ItemPackageDimensions_Height : 4 centimeters
ItemPackageDimensions_Length : 21 centimeters
ItemPackageDimensions_Width : 11 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : spot-welding-equipment
Manufacturer : SHONFYVS
ModelName : Electric Welding Machine
ModelNumber : Jewelry Spot Welding Machine
NumberOfItems : 1
PartNumber : VOYLINTDbtk80gfwzm
PowerSourceType : ac
ProductDescription :

Jewelry Spot Welding Machine Electric Welding Machine 110v Jewelry Pul-se Argon Spot Welder Jewelry Soldering Welder Adjustable pul-se spot welding machine for Gold Silver Platinum

Standard accessories:

• One host
• power cable
• Foot switch
• Workpiece clip
• Tungsten needle
• Torch needle holder
• Instruction manual

Specification:

Power supply: AC110V

Power: 800W

Welding current: 0.5-80A continuously adjustable (pul-se ignition)

Welding range: 0.2-1.3mm

Instructions:

1. Before using the welder, first check if the power supply meets the operating voltage.

2. Connect the welder output wire to the screw of the corresponding output stage (tighten the nut when the output wire is connected to the output pole)

3. When working, clamp the workpiece with the clip on the output black line, close to the tungsten needle (depending on the size and shape of the workpiece, generally the distance between the tungsten needle and the workpiece is between 0.5-1 mm). After the welding position is fixed, Jog the foot switch, and a high-temperature arc between the workpiece and the tungsten needle instantly welds the workpiece.

4. The discharge end of the tungsten needle must be kept sharp before use and during use to maintain a good discharge state.

5. Welding can change the output pul-se current according to the size of the workpiece, the size of the solder joints, and the process requirements (the machine can weld 0.5-1.5MM). When the potentiometer is rotated clockwise, the output pul-se current increases, whereas the output pul-se current decreases.

ProductSiteLaunchDate : 2024-06-29T10:00:31.214Z
Size : 8mm
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
Voltage : 110 volts_of_alternating_current
Wattage : 800 watts