Cart 2 india

Specification
Brand : MAGNATE
BulletPoint : Fish Tail End, Solid Carbide, Right-Hand; 1/4" Shank Diameter; 2" Overall Length
BulletPoint1 : 2-Flute Carbide Tipped; 1/2" Small Diameter; 1-1/2" Cutting Diameter; 1" Cutting Height
BulletPoint2 : 1/2" Shank Diameter; 2" Shank Length
BulletPoint3 : Leak-proof, the screws will not strip when tightened the clamps, high strength makes it firm to connect the devices for long time use.
BulletPoint4 : Easy to connect and disconnect, our hose repair kit ensures many years of dependable water hose repair.
BulletPoint5 : Only this hose repair kit and a screwdriver needed to finish the hose repairing work.
Color : One Color
CutType1 : Carbide-Tipped Cut
CutType2 : Flush-Trim Cut
ExternallyAssignedProductIdentifier : 7695732887666
ExternallyAssignedProductIdentifier1 : 0637881894819
ExternallyAssignedProductIdentifier2 : 637881894819
IncludedComponents : 1
ItemDisplayDimensions_Length : 0.3 inches
ItemName : Magnate 9481 2 Flute Spiral Down-Cut Router Bit - 5.0mm Cutting Diameter, 3/4" Cutting Length
ItemPackageDimensions_Height : 1.2 centimeters
ItemPackageDimensions_Length : 2.4 centimeters
ItemPackageDimensions_Width : 7.4 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : spiral-router-bits
Manufacturer : Magnate
Material : Carbide
ModelNumber : 125130
NumberOfFlutes : 2
NumberOfItems : 1
PartNumber : 9481
ProductDescription : This 2-flute spiral bit is designed for solid wood and wood composites. While it can be used for certain plastic applications, O-flute and Z-flute bits are recommended. While this bit can cut Type I high-density foam, the up-cut bit is recommended over the down-cut one. A down-cut spiral bit is used where a downward chip removal and a good finish on top are required. A down-cut spiral bit provides downward pressure on the material and leaves an excellent finish on the top. Always refer to the operation manual of your router first, in the event that a router bit doesn't come with a speed chart, you may start at about 2,000 rpm slower than the maximum speed described in the chart below. Maximum speed below is for reference only, actual best performance speed varies depending on a number of factors i.e. size of the router bit, the material to be cut, etc. Run 24,000 rpm maximum for 1" overall diameter router bits; Run 20,000 rpm maximum for 1-1/2" overall diameter router bits; Run 18,000 rpm maximum for 2" overall diameter; Run 16,000 rpm maximum for 2-1/2" overall diameter router bits; Run 12,000 rpm maximum for 3" overall diameter router bits; Run 10,000 rpm maximum for 3-1/2" overall diameter router bits;
ProductSiteLaunchDate : 2013-04-14T06:53:14.983Z
Size : 12.7x22.2x35.5
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1
UnspscCode : 27110000