Cart 2 india

Specification
Brand : MAGNATE
BulletPoint : Fish Tail End, Solid Carbide, Right-Hand; 1/4" Shank Diameter; 2" Overall Length
BulletPoint1 : Solid Carbide, Up-Cut ; 1/8" Cutting Diameter; 3 Degree; 1" Cutting Height; 1/4" Shank Diameter
BulletPoint2 : 3" Overall Length
BulletPoint3 : Leak-proof, the screws will not strip when tightened the clamps, high strength makes it firm to connect the devices for long time use.
BulletPoint4 : Easy to connect and disconnect, our hose repair kit ensures many years of dependable water hose repair.
BulletPoint5 : Only this hose repair kit and a screwdriver needed to finish the hose repairing work.
Color : One Color
CutType : Up-Cut
CutType1 : Carbide-Tipped Cut
CutType2 : Flush-Trim Cut
ExternallyAssignedProductIdentifier : 7695732887666
ExternallyAssignedProductIdentifier1 : 0637881826834
ExternallyAssignedProductIdentifier2 : 637881826834
IncludedComponents : 1
ItemDisplayDimensions_Length : 0.3 inches
ItemName : Magnate 2683 3 Flute Tapered Ball Nose Spiral Router Bit - 1/8" Cutting Diameter, 3 Degree
ItemPackageDimensions_Height : 1.2 centimeters
ItemPackageDimensions_Length : 2.4 centimeters
ItemPackageDimensions_Width : 7.4 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : spiral-router-bits
Manufacturer : Magnate
Material : Carbide
ModelNumber : 125130
NumberOfFlutes : 3
NumberOfItems : 1
PartNumber : 2683
ProductDescription : A ball end spiral bit is designed for round bottom cuts, carving, fluting, and 3D modeling. This bit is designed for natural wood, plastic, and aluminum. A up-cut spiral bit is used where an upward chip removal and a good finish on bottom are required. When using an up-cut spiral bit, chip removal is optimized but adequate hold down is also needed. Always refer to the operation manual of your router first, in the event that a router bit doesn't come with a speed chart, you may start at about 2,000 rpm slower than the maximum speed described in the chart below. Maximum speed below is for reference only, actual best performance speed varies depending on a number of factors i.e. size of the router bit, the material to be cut, etc. Run 24,000 rpm maximum for 1" overall diameter router bits; Run 20,000 rpm maximum for 1-1/2" overall diameter router bits; Run 18,000 rpm maximum for 2" overall diameter; Run 16,000 rpm maximum for 2-1/2" overall diameter router bits; Run 12,000 rpm maximum for 3" overall diameter router bits; Run 10,000 rpm maximum for 3-1/2" overall diameter router bits;
ProductSiteLaunchDate : 2013-05-28T09:06:49.309Z
Size : 12.7x22.2x35.5
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1
UnspscCode : 27110000