Cart 2 india

Specification
Brand : Mintcraft
BulletPoint1 : Heavy duty construction
BulletPoint2 : Use with 1/8" thick mirrors
BulletPoint3 : Includes anchors and screws
BulletPoint4 : For interior use
BulletPoint5 : Four mirror holders
Color : Clear
DriveSystem : Slotted
ExteriorFinish : Stainless Steel
ExternallyAssignedProductIdentifier : 7436828953205
ExternallyAssignedProductIdentifier1 : 045734971769
ExternallyAssignedProductIdentifier2 : 0045734971769
ExternallyAssignedProductIdentifier3 : 00075352776897
FinishType : Electroplated
GradeRating : Grade 304
IncludedComponents : Hardware;Fasteners & Hooks;set-screws
ItemName : Mintcraft Ph-1222003L Hvy Dty Mirror Holder 1/8in
ItemPackageDimensions_Height : 1.016 centimeters
ItemPackageDimensions_Length : 13.97 centimeters
ItemPackageDimensions_Width : 7.62 centimeters
ItemPackageQuantity : 1
ItemShape : Block
ItemTypeKeyword : sleeve-anchors
Manufacturer : MINTCRAFT
ManufacturerGrade : Grade 2
Material : Stainless Steel 304
Material1 : Carbon Steel
Material2 : Stainless Steel
MaximumShearStrength : 3645
MeasurementSystem : Imperial
MetalType : Carbon Steel
MetalType1 : Carbon Steel
MetalType2 : Stainless Steel
ModelName : PH-1222003L
ModelNumber : PH-1222003L
NumberOfBoxes : 1
NumberOfItems : 1
NumberOfPieces : 25
PartNumber : PH-1222003L
ProductDescription : Applications
The anchor is made from 304 Stainless Steel. This anchor is designed for use in Concrete, Block, and Brick.

Environment
The anchor is designed for use in a Wet environment.

Head Style
The anchor is a Hex head and is designed to allow the head to sit on top of the surface of the item being attached.

Hole Diameter/Bit Diameter
The anchor requires a 1/2" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 1/2".

Length Anchor
The length of the anchor is 3"
Minimum Embedment
The minimum anchor embedment into the concrete is 1-1/2". Therefore, the anchor must be installed so that a minimum of 1-1/2" of the anchor is embedded into the concrete.

Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 1-1/2". This will ensure that the minimum embedment of 1-1/2" will be met.

Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 1/2" diameter anchor requires the hole in the fixture to be 5/8".

Spacing between Anchors
Each anchor must be spaced a minimum distance of 5" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 2-1/2" from an unsupported edge of the concrete.
ProductSiteLaunchDate : 2008-05-12T23:52:20-00:00
Size : 1/8"
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 10
UnspscCode : 31160000