Cart 2 india

Specification
Brand : Dial
BulletPoint1 : The product is manufactured in china
BulletPoint2 : The product is highly durable and easy to use
BulletPoint3 : Easy installation and easy handling
BulletPoint4 : Zinc-plating provides durability and moderate corrosion protection
BulletPoint5 : Pre-drilling required
BulletPoint6 : ANCHOR SIZE EQUALS HOLE SIZE - Easy to remember correct hole size for best results
Color : 50-Pack
CustomerPackageType : Standard Packaging
DriveSystem : Phillips-Recess
ExteriorFinish : Bronze
ExternallyAssignedProductIdentifier1 : 026529415903
ExternallyAssignedProductIdentifier2 : 0026529415903
ExternallyAssignedProductIdentifier3 : 00026529415903
GpsrSafetyAttestation : 1
GradeRating : Grade 2
ItemDisplayDimensions_Length : 120 centimeters
ItemName : Dial 4159 Sleeve
ItemPackageDimensions_Height : 5.334 centimeters
ItemPackageDimensions_Length : 8.636 centimeters
ItemPackageDimensions_Width : 23.876 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : sleeve-anchors
Manufacturer : Jensen (Home Improvement)
ManufacturerGrade : Grade 2
Material : Steel
Material1 : Brass
Material2 : Bronze
MaximumShearStrength : 3082
MetalType : Stainless Steel
MetalType1 : Carbon Steel
MetalType2 : Zinc
ModelName : 4159
ModelNumber : 4159
NumberOfItems : 1
NumberOfPieces : 50
PackageLevel : unit
PartNumber : 4159
ProductDescription : Applications
The anchor is made from Carbon Steel, and is Zinc Plated. This anchor is designed for use in Concrete, Block, and Brick.

Environment
The anchor is designed for use in a Dry environment.

Head Style
The anchor is a Hex head and is designed to allow the head to sit on top of the surface of the item being attached.

Hole Diameter/Bit Diameter
The anchor requires a 3/8" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 3/8".

Length Anchor
The length of the anchor is 1-7/8"
Minimum Embedment
The minimum anchor embedment into the concrete is 1-1/4". Therefore, the anchor must be installed so that a minimum of 1-1/4" of the anchor is embedded into the concrete.

Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 5/8". This will ensure that the minimum embedment of 1-1/4" will be met.

Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 3/8" diameter anchor requires the hole in the fixture to be 1/2".

Spacing between Anchors
Each anchor must be spaced a minimum distance of 3-3/4" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 1-7/8" from an unsupported edge of the concrete.
ProductSiteLaunchDate : 2007-02-17T04:14:35-00:00
Size : Pack of 1
SupplierDeclaredDgHzRegulation : unknown
UnitCount : 16
UnspscCode : 40150000
ValveType : Float Valve
Voltage : 120 volts