Cart 2 india

Specification
Brand : CONFAST
BulletPoint1 : VERSATILE - Can be installed in a wide variety of masonry, solid concrete, brick or block
BulletPoint2 : 360 DEGREE EXPANSION - Provides consistent holding values in a wide range of base materials
BulletPoint3 : PRE-ASSEMBLED - Ready to install no separate parts required
BulletPoint4 : ALL STEEL PARTS - Heavy duty for the most demanding jobs
BulletPoint5 : ANCHOR SIZE EQUALS HOLE SIZE - Easy to remember correct hole size for best results
ExteriorFinish : Zinc
ItemName : CONFAST 3/8" x 5" Stainless Steel Flat Sleeve Anchor (50 per Box)
ItemPackageDimensions_Height : 3.5 inches
ItemPackageDimensions_Length : 8 inches
ItemPackageDimensions_Width : 4.5 inches
ItemPackageQuantity : 1
ItemShape : Block
ItemTypeKeyword : sleeve-anchors
Manufacturer : CONFAST
Material : Stainless Steel 304
MaximumShearStrength : 3082
MeasurementSystem : Inch
NumberOfItems : 50
NumberOfPieces : 50
PartNumber : SAFS385
ProductDescription : Applications
The anchor is made from 304 Stainless Steel. This anchor is designed for use in Concrete, Block, and Brick.

Environment
The anchor is designed for use in a Wet environment.

Head Style
The anchor is a Flat Countersunk head and is designed to prevent the head from protruding above the surface of the item being attached.

Hole Diameter/Bit Diameter
The anchor requires a 3/8" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 3/8".

Length Anchor
The length of the anchor is 5"
Minimum Embedment
The minimum anchor embedment into the concrete is 1-1/4". Therefore, the anchor must be installed so that a minimum of 1-1/4" of the anchor is embedded into the concrete.

Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 3-3/4". This will ensure that the minimum embedment of 1-1/4" will be met.

Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 3/8" diameter anchor requires the hole in the fixture to be 1/2".

Spacing between Anchors
Each anchor must be spaced a minimum distance of 3-3/4" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 1-7/8" from an unsupported edge of the concrete.
ProductSiteLaunchDate : 2017-06-09T06:35:32.196Z
Size : One Size