Specification Brand : CONFAST BulletPoint1 : VERSATILE - Can be installed in a wide variety of masonry, solid concrete, brick or block BulletPoint2 : 360 DEGREE EXPANSION - Provides consistent holding values in a wide range of base materials BulletPoint3 : PRE-ASSEMBLED - Ready to install no separate parts required BulletPoint4 : ALL STEEL PARTS - Heavy duty for the most demanding jobs BulletPoint5 : ANCHOR SIZE EQUALS HOLE SIZE - Easy to remember correct hole size for best results Color : Silver Gray CustomerPackageType : Standard Packaging DriveSystem : External Hex ExteriorFinish : Stainless Steel ExternallyAssignedProductIdentifier1 : 0749273242716 ExternallyAssignedProductIdentifier2 : 749273242716 ExternallyAssignedProductIdentifier3 : 00044315757716 GradeRating : Grade 304 ItemName : CONFAST 3/4" x 5-1/2" 304 Stainless Steel Hex Sleeve Anchor (10 per Box) ItemPackageDimensions_Height : 3.5 inches ItemPackageDimensions_Length : 9 inches ItemPackageDimensions_Width : 4.5 inches ItemPackageQuantity : 1 ItemShape : Block ItemTypeKeyword : sleeve-anchors Manufacturer : CONFAST Material : Stainless Steel 304 Material1 : Stainless Steel Material2 : Carbon Material3 : Zinc MaximumShearStrength : 7059 MeasurementSystem : inch MetalType1 : Zinc MetalType2 : Stainless Steel ModelNumber : SL50600H NumberOfItems : 10 NumberOfPieces : 10 PartNumber : SAHS34512 ProductDescription : ApplicationsThe anchor is made from 304 Stainless Steel. This anchor is designed for use in Concrete, Block, and Brick.EnvironmentThe anchor is designed for use in a Wet environment.Head Style The anchor is a Hex head and is designed to allow the head to sit on top of the surface of the item being attached.Hole Diameter/Bit DiameterThe anchor requires a 3/4" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.Diameter of Anchor The diameter of the anchor is 3/4".Length Anchor The length of the anchor is 5-1/2"Minimum EmbedmentThe minimum anchor embedment into the concrete is 2-1/4". Therefore, the anchor must be installed so that a minimum of 2-1/4" of the anchor is embedded into the concrete.Maximum Fixture ThicknessThe maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 3-1/4". This will ensure that the minimum embedment of 2-1/4" will be met.Fixture Hole DiameterThe hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 3/4" diameter anchor requires the hole in the fixture to be 7/8".Spacing between AnchorsEach anchor must be spaced a minimum distance of 7-1/2" from each other when measured center to center.Edge DistanceIt is very important not to install the anchor any closer than 3-3/4" from an unsupported edge of the concrete. ProductSiteLaunchDate : 2017-06-09T13:03:10.444Z Size : One Size SpecificUsesForProduct : Concrete SupplierDeclaredDgHzRegulation : unknown UnspscCode : 31161500