Cart 2 india

Specification
Brand : Korpek.com
BulletPoint1 : The anchor works by expanding against the material in which it is embedded. When the hex nut is tightened the conical end is pulled into the dilating sleeve pushing it outward 360° around the anchor into the masonry. They are used to attach threaded rod to cinder block, marble, concrete or thin wall. One advantage of the sleeve anchor is that it can be removed after it's been installed. Another is that the length of the sleeve induces less stress on the substrate than does a wedge anchor
BulletPoint2 : Anchors should be installed with a minimum of 10 anchor diameters between each other and a minimum of 5 diameters from the edge
BulletPoint3 : Another is that the length of the sleeve induces less stress on the substrate than does a wedge anchor. It is well-suited for permanently anchoring heavy equipment to concrete.
BulletPoint4 : Threaded Bolt: AISI 1010 - 1018 cold rolled steel -- Sleeve: AISI 1008 cold rolled steel -- Nut: Shall be made from a low carbon steel which conforms to the following chemical composition requirements: Carbon- 0.58% maximum; Phosphorus- 0.13% maximum; Sul
BulletPoint5 : Threaded Bolt: 18-8 stainless steel -- Sleeve: Type 304 stainless steel -- Nut: Type 304 stainless steel -- Washer: 18-8 stainless steel
ExteriorFinish1 : Stainless Steel
ExteriorFinish2 : Zinc
ItemName : 1/2X2 1/4 Rod Hanger Sleeve Anchor Zinc (Pack Qty 25) BC-5036ASLRH by Korpek
ItemPackageQuantity : 25
ItemTypeKeyword : sleeve-anchors
Manufacturer : Korpek LLC
ManufacturerGrade : Grade 304
Material : Zinc
MeasurementSystem : Inch
ModelNumber : BC-5036ASLRH
NumberOfItems : 25
PartNumber : BC-5036ASLRH
ProductDescription : PICTURES ARE REPRESENTATIVE OF ITEM, BUT ARE NOT OF THE ACTUAL ITEM. Product dimensions, finish, head markings, thread length, stamping shape or forging shape, etc., may differ from picture. Products are guaranteed to meet the specifications to which they are manufactured. Specifications allow for tolerances in dimension and shape, which can vary from lot to lot. The anchor works by expanding against the material in which it is embedded. When the hex nut is tightened the conical end is pulled into the dilating sleeve pushing it outward 360° around the anchor into the masonry. They are used to attach threaded rod to cinder block, marble, concrete or thin wall. One advantage of the sleeve anchor is that it can be removed after it's been installed. Another is that the length of the sleeve induces less stress on the substrate than does a wedge anchor. Anchors should be installed with a minimum of 10 anchor diameters between each other and a minimum of 5 diameters from the edge. Machine Pack Count - Margin error of +/- 5%
ProductSiteLaunchDate : 2021-02-08T18:56:46.646Z
Size : 1/2X2 1/4
SupplierDeclaredDgHzRegulation1 : not_applicable
SupplierDeclaredDgHzRegulation2 : not_applicable
SupplierDeclaredDgHzRegulation3 : not_applicable
SupplierDeclaredDgHzRegulation4 : not_applicable
SupplierDeclaredDgHzRegulation5 : not_applicable