Cart 2 india

Specification
Brand : FLIPSKY
BulletPoint1 : Kindly Reminder: This bluetooth module support Android /IOS mobile device.
BulletPoint2 : Used to communicating between the VESC and VESC Tool (mobile) over BLE. Note that the UART port on the VESC must be enabled with a baud rate of 115200 for this to work. The UART port on VESC can work only under 115200 baud
BulletPoint3 : Operating voltage: 2.0V ~ 12V Onboard Chip: NRF51822
BulletPoint4 : Actual use distance: The distance to communicate with VESC is about 15 meters
BulletPoint5 : Kindly Reminder: This bluetooth module support Android /IOS mobile device.
BulletPoint6 : Top Service: If there are any question or need help , just feel free contact us , we will always here help you out within 24 hours.
Color : Black+Red
CompatibleDevices : Android, IOS mobile devices
ConnectivityTechnology : Bluetooth
ConnectivityTechnology1 : Wi-Fi
ConnectivityTechnology2 : Bluetooth
ConnectivityTechnology3 : GPIO
ConnectivityTechnology4 : Ethernet
ConnectorType : Screw
ControlMethod : application
ExternallyAssignedProductIdentifier : 6954525591977
ExternallyAssignedProductIdentifier1 : 768111516376
ExternallyAssignedProductIdentifier2 : 0768111516376
HardwarePlatform : Arduino
IncludedComponents : S3 Development Board
ItemName : V6 Version 2.4G Wireless Bluetooth Module for Electric Skateboard Based Upon The nrf51_vesc Project Flipsky
ItemPackageDimensions_Height : 27.7 centimeters
ItemPackageDimensions_Length : 0.7 centimeters
ItemPackageDimensions_Width : 21.5 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : single-board-computers
Manufacturer : Flipsky
Material1 : Brass
Material2 : Copper
MemoryStorageCapacity : 256 KB
ModelName : nrf51_vesc
ModelNumber : V6 Bluetooth
MountingType : PCB Mount
NumberOfBoxes : 1
NumberOfContacts : 20
NumberOfItems : 3
NumberOfPoles : 20
OperatingSystem : Linux
PartNumber : V6 Bluetooth
ProcessorCount : 1
ProductDescription : Kindly Reminder: This bluetooth module can only support Android mobile device.
Used to communicating between the VESC and VESC Tool (mobile) over BLE. Note that the UART port on the VESC must be enabled with a baud rate of 115200 for this to work. The UART port on VESC can work only under 115200 baud
Operating voltage: 2.0V ~ 12V Onboard Chip: NRF51822
Actual use distance: The distance to communicate with VESC is about 15 meters
Frequency range: 2.4GHz
2.4 GHz multiprotololl RF receiver
ARM Cortex-M0 32 bit processor
256kB flash & 16kB RAM
PCB size：27mm*13mm
2.0mm seven-pin four-wire connector length：90mm
Antenna length：145mm
net weight：0.006kg

ProductSiteLaunchDate : 2020-05-25T07:17:36.945Z
SupplierDeclaredDgHzRegulation : not_applicable
TotalUsbPorts : 2
UnspscCode : 43201500
Voltage : 5 volts_of_direct_current
WarrantyDescription : 2m
WirelessCommStandard : bluetooth