Cart 2 india

Specification
Brand : SKF
BulletPoint1 : The SKF SPEEDI-SLEEVE is a fast and effective way to refinish worn shaft. It’s quicker than remetalizing or regrinding, and provides an improved sealing system. The outside surface of an SKF SPEEDI-SLEEVE forms an ideal sealing surface. Many popular regrinding and refinishing techniques produce a surface that cannot be properly sealed
BulletPoint2 : The standard range of SKF SPEEDISLEEVE sizes covers shaft diameters from .472” to 8” (12 mm to 200 mm). The SKF SPEEDI-SLEEVE is thinwalled, 0.011” (0,28 mm), and made of high quality stainless steel. The contact surface is wearresistant with a finish of Ra 10 to 20 µin (0,25 to 0,5 µm). No expensive machining or preparation is required before mounting. Downtime is reduced since installation only takes a few minutes
BulletPoint3 : "SKF SPEEDI-SLEEVE. These thin-walled stainless steel shaft repair sleeves can come to immediate rescue when a crankshaft needs a new sealing surface. "
BulletPoint4 : "Low in cost, a SPEEDI-SLEEVE is slipped over the worn area quickly and easily, and provides a surface that is actually harder than that of a new shaft. The same size seal (as the one being replaced) fits snugly onto the new surface. And each SPEEDI-SLEEVE comes as a kit with a disposable installation tool. "
BulletPoint5 : While installation is simple, it must be done with care in order to assure proper results. An installation tool is packaged with every sleeve
ExteriorFinish : Machined
ExternallyAssignedProductIdentifier1 : 085311041553
ExternallyAssignedProductIdentifier2 : 0085311041553
ExternallyAssignedProductIdentifier3 : 00085311041553
FitType : Vehicle Specific
IncludedComponents : Tool Kit
ItemName : SKF 99175 Speedi Sleeve and Tool Kit, Inch, 1.75in Shaft Diameter, 0.750in Width
ItemPackageDimensions_Height : 11.3 centimeters
ItemPackageDimensions_Length : 4.5 centimeters
ItemPackageDimensions_Width : 11.1 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : shaft-hub-locking-devices
Manufacturer : SKF
Material : Stainless Steel
ModelName : Speedi Sleeve
ModelNumber : 99175
NumberOfBoxes : 1
NumberOfItems : 1
OeManufacturer : SKF
PackageLevel : unit
PartNumber : 99175
ProductDescription : This is a great kit, made from 2" DOM with a ¼" wall and a high quality poly bushing inner sleeve bore is 9/16" which gives you a very thick wall thickness that will not become egg shaped with hard use. This combo is great for any application that you need to isolate vibrations. These can be used for motor mounts, cage mounts, transmission and transfer case cross members and many other applications. Our DOM Sleeve with Poly Bushing comes in three lengths.
ProductExpirationType : Does Not Expire
ProductSiteLaunchDate : 2012-07-15T00:00:01-07:00
StreetDate : 2017-11-25T00:00:01Z
Style : SSLEEVE
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1