Cart 2 india

Specification
Brand : cizihuu
BulletPoint1 : The sensor can report distances of up to 2 m (6.6 ft) with 1 mm resolution, but its effective range and accuracy (noise) depend heavily on ambient conditions and target characteristics like reflectance and size, as well as the sensor configuration.(The sensor's accuracy is specified to range from ±3% at best to over ±10% in less optimal conditions.)
BulletPoint2 : VL53L0 can be completed in a frame of the entire measurement operation, usually less than 30ms, the distance is less than 2 meters. This distance measurement allows the camera to focus instantly in both shooting and continuous shooting modes, maintaining the same performance even in low light or low contrast scenes
BulletPoint3 : ranging time less than 30ms; more energy efficient, normal mode of operation power consumption is only 20mW, standby power consumption is only 5μA
BulletPoint4 : The internal laser emits 940nm wavelengths of non-visible light and does not harm the eyes.This eliminates the problem of reddistribution with other infrared proximity detection sensors and enhances the immunity to external light sources
BulletPoint5 : 140 dB, common mode rejection ratio (CMRR) and 36 V common-mode voltage (CMV) within the scope of work to ensure minimal or no changes of offset voltage, which can simplify the error analysis
Color : Blue
GpsrSafetyAttestation : 1
ItemName : 1pcs VL53L0X Laser Ranging Sensor Breakout Laser Distance Module,Blue
ItemTypeKeyword : sensor-blocks
Manufacturer : cizihuu
Material : Copper
PartNumber : 3w9i9tzKSkV-1
ProductDescription : Origin:CN(Origin)
Type:Voltage Regulator
Model Number:VL53L0X V1 V2
Application:Computer

Ranging measurements are available through the sensor's I⊃2;C (TWI) interface, which is also used to configure sensor settings, and the sensor provides two additional pins: a shutdown input and an interrupt output.
PIN Description
VDD Regulated 2.8 V output. Almost 150 mA is available to power external components. (If you want to bypass the internal regulator, you can instead use this pin as a 2.8 V input with VIN disconnected.)
VIN This is the main 2.6 V to 5.5 V power supply connection. The SCL and SDA level shifters pull the I⊃2;C lines high to this level.
GND The ground (0 V) connection for your power supply. Your I⊃2;C control source must also share a common ground with this board.
SDA Level-shifted I⊃2;C data line: HIGH is VIN, LOW is 0 V
SCL Level-shifted I⊃2;C clock line: HIGH is VIN, LOW is 0 V
XSHUT This pin is an active-low shutdown input; the board pulls it up to VDD to enable the sensor by default. Driving this pin low puts the sensor into hardware standby. This input is not level-shifted.
ProductSiteLaunchDate : 2021-11-15T10:23:07.321Z
SportType : Shooting
UnspscCode : 46171600