Cart 2 india

Specification
Brand : Glacier Tanks
BulletPoint1 : Connection Type(s): Tri Clamp / FNPT
BulletPoint2 : Connection Size(s): 3/4 in. / 1/2 in.
BulletPoint3 : Stainless Steel: SS304
Color : Stainless Steel
ConnectorType : Adapter
ExteriorFinish : Stainless Steel
ExternallyAssignedProductIdentifier1 : 0019985980498
ExternallyAssignedProductIdentifier2 : 019985980498
IncludedComponents : Adapter
ItemName : NPT Adapter | Tri Clamp 3/4 inch x FNPT 1/2 in. - Stainless Steel SS304 - Glacier Tanks
ItemPackageDimensions_Height : 1.98 inches
ItemPackageDimensions_Length : 4.14 inches
ItemPackageDimensions_Width : 1.98 inches
ItemPackageQuantity : 1
ItemShape : Round
ItemTypeKeyword : sanitary-tube-fittings
Manufacturer : Glacier Tanks
Material : Stainless Steel
MetalType : Stainless Steel
ModelName : H-PJ-NPT316
ModelNumber : 1/4" x 1.5"TC
NumberOfItems : 1
NumberOfPieces : 1
NumberOfPieces1 : 1
NumberOfPieces2 : 2
PartNumber : 22MP-G075-050
ProductDescription :

Notice About Bundle Packs:
Please understand our bundle packs share from a communal inventory. A buyout of one pack type will consume inventory of other packs. Due to limitations, our system has a delay in updating other pack stock quantities. Thank you graciously for understanding.

National Pipe Taper (NPT) are a standardized fitting that is commonly used for joining pipe. Due to the tapered threads (wider diameter at the base of the threads, similar to a trapezoid) the male fitting will tighten the further it is threaded into the female. NPT follows the technical standards provided by the American National Standard Pipe Thread standards, often called national pipe thread, which is often where the confusions with NPT arises, as NPT is specifically an acronym that referes to tapered pipe.

National Pipe Straight (NPS) are straight thread that is sized to be compatible with common water heater elements and should be compatible with most NPS straight threads.

Determining NPT/NPS Size:
Sizing NPT/NPS is based on the nominal pipe diameter, and not the ouside diameter (OD) of the threads. For example: A 1/2" NPT male has an outside thread diameter of approximately 3/4", but as stated the correct NPT size is 1/2", including the counterpart female.

Notice: While NPT and NPS threads may be joined together, their threads may not form a proper seal, be loose fitting, or otherwise not an optimal connection.

ProductSiteLaunchDate : 2020-04-07T18:15:43.022Z
Size : (Single - Save 0%)
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1
UnspscCode : 40141700