Cart 2 india

Specification
Brand : Blue Demon
BulletPoint : These electrodes are suitable for welding carbon steel and low-alloy steel in structural steel
BulletPoint1 : The extra low carbon provides good resistance to carbide precipitation and corrosion
BulletPoint2 : ER309L works well for dissimilar joints that undergo heat treatment
BulletPoint3 : AWS A5.9, Welding Current DCEN
BulletPoint4 : Country of Origin: ‎India
BulletPoint5 : These Electrodes are available in Sizes: 3/32" and 1/8" - Available Packages: 0.5 Lb, 2 Lb and 4.4 Lb - Select your option from the Size Menu - Check Picture #2 for an approximate number of electrodes per pound - 3/32" electrodes are 12" long and 1/8" electrodes are 14" long
Color : Silver
ExternallyAssignedProductIdentifier : 00840338563415
ExternallyAssignedProductIdentifier1 : 652426012459
ExternallyAssignedProductIdentifier2 : 0652426012459
IncludedComponents : 2 lbs of er309l 3/32" welding wire
ItemDisplayWeight : 2 pounds
ItemName : BLUE DEMON ER309L 3/32IN X 36IN X 2LB TUBE, Silver (ER309L-094-02T)
ItemPackageDimensions_Height : 94.615 centimeters
ItemPackageDimensions_Length : 2.54 centimeters
ItemPackageDimensions_Width : 2.54 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : arc-welding-rods
Manufacturer : Welding Material Sales
Material : carbon
ModelName : ER309L-094-02T
ModelNumber : ER309L-094-02T
NumberOfItems : 1
PackageLevel : unit
PartNumber : ER309L-094-02T
ProductDescription : Instructions: Use DC+ (reverse polarity), however, an AC machine with sufficient open circuit voltage may be used. Bevel thick sections to a 60° Vee. Clean the weld zone of all contaminants. Preheating 300 series stainless steel is NOT required. The diameter of the electrode chosen should be equal to the thickness of the base metal. Use the lowest possible welding current or increase your welding speed in order to avoid overheating or distortion of the base metal. Overheating stainless steel can degrade the composition and corrosion resistant properties. The arc length should be kept as short as possible but do not touch the flux-coating of the electrode into the molten weld pool. Hold the electrode at a 15° angle into the direction of travel. Stringer beads should be used in the flat, horizontal, and overhead positions. The weaving technique should be used for vertical welding but not to exceed two to three times the diameter of the electrode. Remove all slag before making additional passes. On the final pass, allow the part to cool down partially before removing the slag, then promote rapid cooling by quenching with a wet rag or compressed air. This will preserve the corrosion resistant properties of the 300 series stainless. Do not allow to slow cool.
ProductSiteLaunchDate : 2022-06-14T16:14:45.867Z
Size : 3/32"
Style : 2# Tube
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 23271800