Cart 2 india

Specification
Brand : Panopticon Tech
BulletPoint1 : 1 White ABS Normally Closed Miniature Door Contact Switch 5/8 by 3/8 with screw terminals to terminate alarm system wires
BulletPoint2 : .2 Amp Maximum Switch Current
BulletPoint3 : Will Sense Door Closer at Roughly 1/2” or 10mm
BulletPoint4 : This Contact Works with Any Access Control or Burglar Alarm System Available
BulletPoint5 : NORMALLY CLOSED: When the door or window is open, the contact will give an open signal and when the door is closed the contact will give a closed (circuit) signal.
CircuitType : 1-way
Color : Silver Gray
ConnectivityProtocol : X-10
ConnectorType : Screws
CurrentRating : 0.5 amps
ExternallyAssignedProductIdentifier1 : 0729910956404
ExternallyAssignedProductIdentifier2 : 729910956404
ExternallyAssignedProductIdentifier3 : 00793574633230
IncludedComponents : One (1) Reed Switch/Sensor Assembly^Two (2) Nylon Jam Nuts
InternationalProtectionRating : 100 volt
ItemName : 1 White Recessed Screw Terminal Block Door Contacts NC Alarm Door Window Sensors with Magnetic Reed Switch. These 38 Door Contact Position switches DCS Work
ItemPackageDimensions_Height : 0.5 inches
ItemPackageDimensions_Length : 6 inches
ItemPackageDimensions_Width : 1 inches
ItemPackageQuantity : 1
ItemTypeKeyword : reed-switches
LightType : Non-Illuminated
LowerTemperatureRating : -40 degrees_celsius
Manufacturer : AuthorizID
Material : Metal
ModelNumber : a20122601ap0066
MountingType : Door Mount
NumberOfBoxes : 1
NumberOfItems : 1
NumberOfPositions : 1
OperatingVoltage : 100 volts
OperationMode : Off
PackageLevel : unit
PartNumber : RSCWDAU-1
ProductDescription : These are the door contact sensors that are in use with any and all commercial or residential card access systems as well as all security burglar alarm system. The door position switches operate with a built an internal magnetic reed switch that closes when the opposing magnet comes within 3/4” of the door sensor. Hence when the door opens beyond the ¾” point the door position switch will switch from a closed signal to an open signal. When this happens the access control system or alarm system will sense the change in continuity and will know that the door or window has been opened. When the door or window shuts, the door sensor will notify your security system that the opening has been closed. 2 screw terminal ports to wire up alarm system wires. No need for wire crimping. Very easy to install.
ProductSiteLaunchDate : 2017-01-10T08:00:00.000Z
Size : MC-51 NC/NO
SpecificationMet : UL
StreetDate : 2017-05-15T00:00:01Z
SupplierDeclaredDgHzRegulation : not_applicable
SwitchType : Temperature Switch
TerminalType : Spdt
UnitCount : 1
UnspscCode : 39122200
UpperTemperatureRating : 140 degrees_fahrenheit
Voltage : 100 volts
Wattage : 10 watts