Cart 2 india

Specification
Brand : SWAG Offroad
BulletPoint1 : Made in the USA
BulletPoint2 : Fully Machined Black Oxide Thumb Knob
BulletPoint3 : Return Spring for ease of Ram Retraction
BulletPoint4 : Machined Plate for mounting your formed Ram Mount to your Bender
BulletPoint5 : Kit comes with all 3
ExternallyAssignedProductIdentifier1 : 0889944080848
ExternallyAssignedProductIdentifier2 : 889944080848
ItemName : SWAG Off Road Machined Thumb Knob, Return Spring, and Tube Bender Mounting Plate
ItemPackageDimensions_Height : 3.8 inches
ItemPackageDimensions_Length : 14.4 inches
ItemPackageDimensions_Width : 3.5 inches
ItemPackageQuantity : 1
ItemTypeKeyword : rebar-cutters-and-benders
Manufacturer : SWAG Offroad
Material : Machined steel, Elastic
OeManufacturer : JEGS
PartNumber : ACCTBRSBMBBMTK
ProductDescription : Elastic Return Spring

Imagine how much easier your job is going if your not having to manually retract your tube bender every time you need to re-pin your die set. The 100 pound of resistances offer by this return spring is backwards compatible with our Air/Hydro tube bender ram mount. No tools required for installation just hook it up to your bender and the back side of your 8 ton ram and your done.

The springs are made of rubber tubing that's encapsulated in a polypropylene fabric sleeve for excellent wear resistance. Air/hydro Ram Mount Bracket: Looking to save time? If you did not purchase a mounting pedestal to mount your tubing bender you will need to make a mounting plate.

This bracket is laser cut out of 3/8" steel plate and is compatible with every tube bender that fits our air/hydraulic ram mount kits.

Please note: If you purchased our formed air/hydro ram mount this mounting bracket is not included with your purchase. Machined Thumb Knob: We save you the hassle of using the 18" long handle to open and close the pressure release valve on your 8 ton ram. Fully machined with a black oxide finish and built to last. To install you simply press out the roll pin on the 8 ton ram side over the SWAG machined thumb knob then reinstall the roll pin.

*NOTE* : Some of the newer HF 20 ton jacks have a T-handle one piece design for pressure release valve. In order to install our thumb knob on this design, additional modifications are required.

Please provide a valid address USPS delivers too.
ProductSiteLaunchDate : 2018-07-23T07:00:00.000Z
Style : Thumb Knob, Return Spring, and Machined Plate