SpecificationBrand : HANGKAI
BulletPoint1 : 6" Disc -- The disc of this sander is 6" in diameter. You can change and install different types of sandpaper of the right size easily.
BulletPoint2 : 6 Dust Extraction Holes -- At the bottom of the sander disc, which allows you to extract dust while sanding. It is healthier to sand in a dust-free environment and can also improve work efficiency.
BulletPoint3 : Loop Face Design -- The disc of this sander is designed to be looped, which not only allows for good loop sanding to every place but also makes it easier to change sandpaper.
BulletPoint4 : Filter -- The air inlet has a filter that prevents foreign objects from entering. It can ensure that the incoming air is cleaner.
BulletPoint5 : Application -- This item is suitable for rust removal, sanding and fine polishing of iron, wood, plastic, metal, rubber, stone, marble and other materials.
ExternallyAssignedProductIdentifier1 : 0758439380377
ExternallyAssignedProductIdentifier2 : 758439380377
IncludedComponents1 : 1* Air Sander
IncludedComponents2 : 1* Wrench
IncludedComponents3 : 1* Dust Extraction Tube
IncludedComponents4 : 1* Nozzle
IncludedComponents5 : 1* Bag
ItemName : 6“ Random Orbit Sanders,10000 rpm,Orbital Sander Tool,15cm Sander Disc Low Noise Random Orbit Air Sanders w/Dust Extraction Tube
ItemTypeKeyword : power-random-orbit-sanders
Manufacturer : Amobink
MaximumCurrent : 10 amps
MaximumRotationalSpeed : 10000 rpm
ModelName : 6“ Random Orbit Sanders
ModelNumber : OT-ZJGJ-1250-240
PowerSourceType : Corded Electric
ProductDescription :
Specifications
Rotor Material: Steel
Maximum Rotate Speed: 10000 rpm
Gross Weight: 1.28kg/2.82 lbs
Sander Disc Diameter: 15cm/6"
Package Size: 19.8*13*11cm/7.8*5.12*4.33"
Product Size: 15*13*10.5cm/6*5.1*4.1"
Package Included
1* Air Sander
1* Wrench
1* Dust Extraction Tube
1* Nozzle
1* Bag
Notes
1.Please check that all fastening parts of the tool are intact before operation.
2.Please release the air source when replacing the sandpaper or backing pad.
3.Please wear protective glasses, goggles, dust masks and gloves when operating.
4.Take a break every 30 minutes to avoid possible injuries caused by fatigue.
5.After the operation, please drain the water from the air compressor and air hose.
6.The optimal hand pressure for the tool during operation is 5 kg to 7 kg.
7.Do not rotate freely at high-speed to avoid injury to your body and possible damage to the tool. Please do not touch the rotating part of the tool with your hand or body during operation.
8.When you notice any irregular sound or vibration during operation, please stop your work, then check and repair the tool.
9.Because you are operating with clean compressed air. Please use an air filter at the air installation to clean the dust in the compressed air.
10.Any dust inside the motor may cause the rotation to slow down or even stop running. In this case, you can try to drop some oil at the entrance of the tool and then run it slowly for a minute and finally start working.
ProductSiteLaunchDate : 2024-01-18T07:09:21.108Z
SupplierDeclaredDgHzRegulation : unknown
UnitCount : 1