Cart 2 india

Specification
Brand : PRO-EDGE INDUSTRIAL PNEUMATICS AND CONTROLS
BulletPoint : Price for Pack of 100 pcs
BulletPoint1 : 5/16" Tube O.D. x 1/4" MNPT Male Branch Tee
BulletPoint2 : 0-150 PSI Working Pressure Range of the Fitting. Please reference the working / burst pressure of the tubing type you plan on connecting to this fitting for the most accurate Maximum PSI rating
BulletPoint3 : Min Burst Pressure of 340PSI (23BAR), Working Temperature Range of 0° - 160° F
BulletPoint4 : Composite and Brass Body, Stainless Steel Gripper and NBR 70 O-Ring
BulletPoint5 : Please Note 1/4" NPT Measures 0.540" Outside thread diameter in inches. See attached NPT Thread chart.
Color : Brass
ConnectorType : Tee
ExteriorFinish : Brass
ExternallyAssignedProductIdentifier1 : 768694644657
ExternallyAssignedProductIdentifier2 : 0768694644657
ItemName : 5/16" Tube O.D. x 1/4" MNPT Brass Composite Push-In Male Branch Tee, Pneumatic Fitting (QTY 1)
ItemPackageDimensions_Height : 12.3 centimeters
ItemPackageDimensions_Length : 2.4 centimeters
ItemPackageDimensions_Width : 7.5 centimeters
ItemPackageQuantity : 1
ItemShape : Straight
ItemTypeKeyword : push-to-connect-tube-fittings
Manufacturer : PRO-EDGE INDUSTRIAL PNEUMATICS AND CONTROLS
Material : Brass
Material1 : Polyvinyl Chloride
Material2 : Polyethylene
ModelName : EXA-H-CLAMP-8IN
ModelNumber : CPLV-137
NumberOfItems : 5
NumberOfPieces : 5
PartNumber : CPLV-137
ProductDescription : Pro-Edge Industrial push-in fittings, also known as Push-to-pull, push-to-connect, push-fit, or instant fittings, let you easily connect hoses in your compressed air system. They are a type of easily removed fittings that allow an air line to be attached. These fittings act similar to the way regular compression fittings work, but use a resilient O-ring (NDR 70) for sealing, and a grip ring (stainless steel) to hold the tube in place. The main advantages of this technology over traditional soldered copper or glued plastic are that fittings can easily be unmounted and re-used, speed of assembly, assembly when wet and that the joints are still rotatable after connection The issues that can cause joint failure are not pushing the pipe in far enough, not having a smooth round end to the pipe, too rough a pipe surface under the O-ring and detritus in the mechanism. Deburring the end of the pipe is vital to avoid damaging the O-ring on insertion, and the pipe surface under the ring must be smooth to get an adequate seal. The pipe end should be square so it sits against the stop in the fitting and does not cause turbulence. It is quite easy to push the pipe in only as far as the grab ring, or the O-ring, and not all the way to the stop. This fitting has a body made of Composite Polyacetal (hemopolymer, copolymer) and brass. The tube release is made of acetal resin. The retainer and spacer is made of brass, and the threads are made of brass, with white sealant, when applicable.
ProductSiteLaunchDate : 2022-06-21T12:25:13.798Z
Size : 3/8"OD
Style : QTY 1
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 40141700