Cart 2 india

Specification
AgeRangeDescription : adult
Brand : DWFSKZKV
BulletPoint : Performance: Input Power Voltage: 110V ~ 220V AC. Output voltage: 50V-220V (output voltage <= input power voltage). Maximum power output: 2000W. Maximum output current: 25A.
BulletPoint1 : Operating Voltage: DC 5V - 36V; The trigger source: digital high-low (DC3.3V - 20V); continuous current: 15A, enhance cooling conditions, the maximum current up to 30A; power: 400W.
BulletPoint2 : High Reliability, High Availability: It adopts double MOS parallel active output to show lower internal resistance,greater electric current and power. Besides it works at 15A,400W under common temperature which satisfies most devices usage and realizes the control of great power devices in a relaxed way.
BulletPoint3 : Supporting Multiple Signal Source Triggers: Can be connected microcontroller IO port, PLC interfaces, DC power, etc.
BulletPoint4 : PERFECT SUPPORT PWM: You can access the PWM signal, the signal frequency 0--20KHZ perfect support.
BulletPoint5 : WIDELY APPLICATIONS:You can control the output of power equipment, motors, light bulbs, LED lights, DC motors, micro-pumps, solenoid valves, etc., can input PWM, control motor speed, lamp brightness and so on.
Color : Sg6800e
ConnectorType : Auxiliary
ExternallyAssignedProductIdentifier : 7310401352527
ExternallyAssignedProductIdentifier1 : 605145001044
ExternallyAssignedProductIdentifier2 : 605145000641
ExternallyAssignedProductIdentifier3 : 0605145001044
ExternallyAssignedProductIdentifier4 : 0605145000641
FinishType : Black
Horsepower : 2000 watts
IncludedComponents : Controller
InputVoltage : 13 volts
ItemName : DWFSKZKV SG6800E Electric Speed Controller Engine Governor Board with Chip DC Motor Control Module Diesel Generator Accessories(SG6800E)
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : process-controllers
Manufacturer : DWFSKZKV
Material : Copper
ModelName : DWFSKZKV
ModelNumber : DWFSKZKV
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : DWFSKZKV
ProductDescription : SG6800E
APPLICATION INFORMATION
The SG6800E Series speed control unit is rugged enough to be placed in a control cabinet or engine mounted enclosure with other dedicated control equipment. if water, mist, or condensation may come in contact with the controller, it should be mounted vertically. This will allow the fluid to drain away from the speed control unit.
"WARNING
"
An overspend shutdown device, independent of the governor system, should be provided to prevent loss of engine control which may cause personal injury or equipment damage. Do not rely exclusively on the governor system electric actuator to prevent overspend.A secondary shutoff device, such as a fuel solenoid must be used.
Basic electrical connections are illustrated in Diagram 1.Actuator and battery connections to Terminals A, B, E, and F should be #16 AWG (1.3 mm sq.) or larger. Long cables require an increased wire size to minimize voltage drops.
The battery positive (+) input, Terminal F, should be fused for15 amps as illustrated.
Magnetic speed sensor connections to Terminals C and DMUST BE TWISTED AND/OR SHIELDED for their entire length. The speed sensor cable shield should ideally be connected as shown in Diagram 1. The shield should be insulated to insure no other part of the shield comes in contact with engine ground, otherwise stray speed signals may be introduced to the speed control unit. With the engine stopped, adjust the gap between the magnetic speed sensor and the ring gear teeth. The gap should not be any smaller than 0.020 in.(0.45 mm). Usually, backing out the speed sensor 3/4 turn after touching the ring gear tooth will achieves satisfactory air gap. The magnetic speed sensor voltage should be at least 1 VAC RMS during cranking.
ProductSiteLaunchDate : 2024-06-11T09:30:23.336Z
Size : One Size
SkipOffer : 1
SpecificUsesForProduct : ELECTRONIC_ADAPTER
Style : FET 1
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 26111500
Voltage : 110 volts
Wattage : 400 watts