Cart 2 india

Specification
AgeRangeDescription : adult
Brand : DWFSKZKV
BulletPoint : Engine Interface Module EIM BASIC MK3 258-9753 Speed Controller Diesel Generator Engine Motor Charge Regulator 258-9755
Color : One Color
ExternallyAssignedProductIdentifier : 7310389550984
ItemName : DWFSKZKV 3062322 Generator Speed Controller Module Diesel Electric Govornor Engine Control Circuit Board Genset Parts
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : process-controllers
Manufacturer : DWFSKZKV
Material : Copper
ModelName : DWFSKZKV
ModelNumber : DWFSKZKV
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : DWFSKZKV
ProductDescription : Generator Speed Controller 3062322
Brief introduction of functions:
3044196(speed controller) is a design with full electrical closed-loop path control function, which can control engine perfectly when connecting with the matched actuator in EFC system, as it can control the engine speed rapidly and accurately once getting instantaneous loading change.
2, Specification:
a, Electric Specification:
<;±0.25%
Speed Range: 1KHz ~ 6.5KHz
Thermal stability: Max ±0.7%
IDLE Regulation: 260 ±20Hz
DROOP Regulation: Minimum 15Hz ±6Hz/ 1 Amp; Maximum: 400Hz ±75Hz/ 1 Amp
External Speed Regulation: ±200Hz (with 1 K connected)
AUX Input Sensitivity: 148Hz / 1V., ±10Hz
Impedance: 1M
b, ENVIRONMENT:
Working Temp Range: -40 ~ 85
Working Humidity Range: Maximum 95%
Stocking Temp: -55 ~ 92
Shocking: 20-100HZ 500mm/Sec.
c, INPUT POWER SUPPLY
Voltage: 12V or 24V
Grounding Pole: Negative pole
Power Supply: 40mA
Actuator Continuous Current: Minimum 1A, Maximum 4.5A
MPU Signal: 2 ~ 120V RMS
NOTE: Above-Mentioned parameters are tested with a 3800Hz working frequency.
3, Installation
please use antiskid self-lock screw to install after making hold in the suitable places according to the following data.
the distance between the center and four hole is 135mm*102mm, the diameter of the hole is 5.5mm.
Terminals' introduction is as below:
Speed controller
No.1,No.2 terminals: 1 is DC positive, 2 is DC negtive.
No.3,No.4 terminals are the output connector of ACTUATOR
No.5,No.6 terminals are the input connections of MPU
No.7,No.8,No.9 terminals are external RPM fine tuning
No.10 is the connector of idle-speed switch
No.11 terminal is free connector
4, adjustment
The speed controllers shall be adjusted before sending out from , but it can be adjusted slightly again during the operating according to different engine models, the operation is as below:
ProductSiteLaunchDate : 2024-05-24T12:52:49.127Z
Size : One Size
UnitCount : 1
UnspscCode : 52140000
Voltage : 24 volts