Cart 2 india

Specification
Brand : sara-u
BulletPoint1 : Support multi-layer overlay to increase power and capacitance.
Support subsequent expansion modules, support single-sided or double-sided battery.
BulletPoint2 : High current wiring, Full-chip high-current protection board and battery holder.
High Conversion efficiency, Support multi-layer balanced release.
BulletPoint3 : With over-voltage protection function to prevent overshoot or over-discharge.
With voltage equalization function, to ensure that multiple sets of voltage are the same, increase the life of the battery pack.
BulletPoint4 : The protection plate can provide a balance equalization function for the entire multi-layer battery case, without having to add a protection plate to each layer.
Easy and simple to use and operate, no other tools needed to install.
BulletPoint5 : Installation: Install the battery according to the positive and negative sides on the circuit board. Be careful not to reverse it.
Color : 1
CurrentRating : 2 amps
ExternallyAssignedProductIdentifier : 7438690098305
IncludedComponents1 : inc
IncludedComponents2 : inc
IncludedComponents3 : inc
IncludedComponents4 : inc
IncludedComponents5 : inc
ItemName : Sara-u 6S Power Wall 18650 Battery Pack Holder Power Bank Case Balancer BMS PCB Circuits Protection Board DIY Kit
ItemPackageDimensions_Height : 2 centimeters
ItemPackageDimensions_Length : 8 centimeters
ItemPackageDimensions_Width : 6 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-power-transformers
Manufacturer : sara-u
Material : metal
MaximumFrequency : 1 MHz
MinimumFrequency : 50 hertz
ModelNumber : SCT036TS
PartNumber : sara-u20201014
PowerSourceType : Battery Powered
ProductDescription : Specifications:
Item Type: Battery Holder Protection Board
Material: plastic+metal+electronic components
Size: 151x85mm/5.9x3.3in
Color: As shown
Optional Type: 1: Single-sided battery holder, 2: Double-sided battery holder, 3: Single-sided battery holder with protection board
Voltage: 24V
Current: 40A
Quantity: 1 PC

Warm Tips:
25.2v charger is needed for 6S charging.
It is recommended that the charging current of each layer should not exceed 2A, otherwise the battery may become hot (for example, choose 2A charger for only one layer, and 4A charger for two layers).
Do not put on the metal table top to use, pay attention to insulation do not short circuit.
The battery faces up the circuit board, all the batteries face the same cannot interleave.
Do not connect the wrong power supply, the circuit board is marked, pay attention to the observation.

Note:(Battery not included)
Transition: 1cm=10mm=0.39inch
Please allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.
Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!

Package Includes:
1 Set x Battery Holder Protection Board Kits
(Not include the balance line shown in the picture)
ProductSiteLaunchDate : 2020-10-14T08:18:56.000Z
Size : one