Cart 2 india

Specification
Brand : SaNzia
BulletPoint : Power Transformers
BulletPoint1 : Rainproof
BulletPoint2 : General purpose
BulletPoint3 : Type 3R
BulletPoint4 : Field clearance side and top 6" min
BulletPoint5 : 【Customer First】If you are unsure of the size or have any questions about the product or service, or want to customize the voltage please feel free to email us, We will reply you within 12 hours
Color : 10KW
CurrentRating : 6.6 amps
ExternallyAssignedProductIdentifier : 7700913367124
ExternallyAssignedProductIdentifier1 : 0785901020226
ExternallyAssignedProductIdentifier2 : 785901020226
IncludedComponents : 1*Toroidal transformer + 1*Accesorries sets
ItemName : 15KW Three-Phase Intelligent Electronic servo Transformer 380V to 220V to 200V 8KW/9KW/10KW/11KW/12KW/13KW/14KW/15KW (Color : 10KW)
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-power-transformers
Manufacturer : SaNzia
Material : Copper
MaximumFrequency : 60 hertz
MinimumFrequency : 50 hertz
ModelNumber : RS-35-12
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : SaNzia
PowerSourceType : Corded Electric
ProductDescription : Power Transformers
Please note: This transformer can only be used on servos.
Product parameters
Input voltage: three-phase four-wire (360V-415V)
Output voltage: three-phase three-wire (200V-230V)
Frequency: 50HZ/60HZ
installation steps
1. RST is connected to the three-phase 380V hot line
2. N is connected to the neutral wire. It is recommended that the diameter of the neutral wire be 1.4 times the diameter of the live wire (see Table 2.1 for the recommended specifications of the transformer input neutral wire), and the connection must be firm.
Table 2.1 Recommended specifications for transformer input neutral wire:
Power (KW) Input zero line (mm2)
2/3 / 4.5 2.5
5.5 / 7.5 4.0
11/15 6.0
20/25/30 10.0
3. No-load inspection (without servo driver): connect RSTN and power on. Use a multimeter DC meter to measure the voltage between L1 and L3. The normal voltage is 190±10V. If these two points are abnormal, do not connect to the server;
4. Turn off the power supply and connect the servo driver, transformer L1, L2, L3; otherwise, the servo driver will not work normally.
5. Where single-phase 220V power is used on the equipment (such as 220V cable system, 220V power supply
heat fan, etc.), you can use a live wire and a neutral wire to take power before the servo transformer;
6. Repeatedly check the above circuit, and turn it on after confirming that it is correct. The servo drive shows that it is ready to work.
ProductSiteLaunchDate : 2023-09-09T10:52:39.369Z
SpecificationMet1 : CSA
SpecificationMet2 : UL
Style : Primary Voltage (AC) :220V
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1
UnspscCode : 60141000