Cart 2 india

Specification
Brand : Brooks AG Parts
BulletPoint : Chuck wire, outer circle: 93mm, inner circle: 50mm, thickness: 15mm
BulletPoint1 : 1-3/8" Smooth Bore Female End
BulletPoint2 : 1-3/8" Smooth Shaft Male End
BulletPoint3 : Grade 8 Mounting Hardware Included
BulletPoint4 : 7mm Adjustable clutch springs, 10mm Adjusting bolts
BulletPoint5 : Adjustable / Replaceable Friction Disc, from 20 - 55 Horse Power
ExternallyAssignedProductIdentifier1 : 0601959632528
ExternallyAssignedProductIdentifier2 : 601959632528
ItemName : Add on Rotary Cutter Slip Clutch Easily Add a Slip Clutch to Your Shear Bolt PTO
ItemTypeKeyword : mechanical-power-take-offs
Manufacturer : Brooks AG Parts
NumberOfItems : 43
PartNumber : ISC-SMooth
ProductDescription : This listing is for one independent adjustable slip clutch with a 1-3/8" smooth male shaft and a 1-3/8" smooth bore female end with two (2) grade 8 mounting bolts and nuts! Do you have a rotary cutter that has a shear bolt protected gearbox and wish it had a slip clutch? Have you had to replace your gearbox or repair the PTO on your tractor because the shear bolt failed to shear and damaged your gearbox or tractor? Have you found a good used mower but it does not have a slip clutch and you wish is did? Are you using a rotary cutter that has a 40hp rated gearbox on your tractor that has a lower horse power rating and thinking that the shear bolt which is designed to shear at 40hp will shear early enough to protect your 30hp tractor before it is damaged! Here is an easy way to add an adjustable slip clutch to your rotary cutter without having to purchase a complete expensive PTO shaft! Just remove your smooth bore shear bolt protected PTO shaft from your cutters gearbox by removing the shear bolt and retaining clip, discard the shear bolt and clip, slide this adjustable slip clutch onto the gearbox shaft and align the hole in the adjustable slip clutch with the corresponding hole in the input shaft of the gearbox and insert and tighten the grade 8 bolt and nut (non shear bolt) to mount the clutch. Then attach the smooth bore yoke of your PTO shaft to the slip clutch's smooth male shaft, align the holes and insert and tighten the second grade 8 mounting bolt and nut and the unit is installed. Check to make sure that the PTO shaft has enough clearance as you slowly raise and lower your mower with your tractors hydraulics and make sure the shaft doesn't bottom out causing the shaft to bend. If you need to shorted the shaft slightly to allow for proper clearance remove the shaft from the adjustable slip clutch, slide the two sides of the PTO apart and cut an equal amount off of each side as needed, reinstall the PTO shaft to the adjustable clutch and recheck for necessa
ProductSiteLaunchDate : 2023-12-19T17:00:18.598Z
UnspscCode : 31161500