Cart 2 india

Specification
Brand : HJW Electronics
BulletPoint1 : Single gang mono potentiometer by Bourns
BulletPoint2 : 6.0mm standard metric flatted D-shaft
BulletPoint3 : 16mm potentiometer body size
BulletPoint4 : Linear B track taper
BulletPoint5 : Various track resistances available
CompatibleMaterial : Diy
ExternallyAssignedProductIdentifier : 5060971148069
ExternallyAssignedProductIdentifier1 : 0738585396484
ExternallyAssignedProductIdentifier2 : 738585396484
IncludedComponents : 1 potentiometer, 1 washer, 1 nut
ItemName : Potentiometer Linear Taper 16mm Body 6.0mm Flatted D Shaft B BD (B5K)
ItemPackageDimensions_Height : 2 centimeters
ItemPackageDimensions_Length : 8 centimeters
ItemPackageDimensions_Width : 5 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-components
Manufacturer : BN
Material : carbon
ModelNumber : B BD
NumberOfItems : 1
PartNumber : B BD
ProductDescription : 16mm Flatted D Shaft Linear Track Potentiometer, Lin B Pot by Bourns. This is one item of new, single gang, linear track potentiometer which has a standard 6mm D-shaped flatted shaft manufactured by Bourns. The turning shaft length is 14mm and the threaded section of the shaft is 6mm. A nut and a washer are included for mounting on a front panel. The mounting hole required is 7mm diameter. The connection pins will allow either PCB mounting or soldered wire connections. The "B" prefix before the track resistance value denotes the linear track taper. The max power rating is 0.2W. The track tolerance is +/-20%. Some of the different track resistance variations are carbon based and some of them are conductive plastic. Those showing the stylised "B" on the back are carbon track types. Those showing the P160 engraving are conductive plastic based. The photographs on each resistance variation are correct in each case. The pin spacing is 5mm The shaft diameter is the standard 6mm metric size The width across the flat is a little over 5mm, standard size. The 'diameter' across the curve to the flat is 4.5mm. The flat points downwards towards the centre pin when the pot is at the mid-point. The rotation angle is 300 degrees. If you have a pot with a track label of B503, this is a linear 50K where 3 is the number of zeros after 50 in Ohms. A 502 would be 5K, a 472 would be 4K7 etc. Sometimes pots may also be labelled with the B as a suffix i.e. 50KB. B500R = 500 Ohms.
ProductSiteLaunchDate : 2024-02-01T19:22:12.037Z
Style : B5K
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 32000000