Cart 2 india

Specification
Brand : Brady
BulletPoint1 : Banding each end of a pipe marker with directional flow arrow tape is recommended
BulletPoint2 : Style 1 pipe markers measure 2-1/4 in. x 14 in., come one marker per card, and fit pipe diameter 2-1/2 in. to 7-7/8 in.
BulletPoint3 : High gloss, durable, flexible vinyl with a permanent cold temperature pressure sensitive acrylic adhesive
BulletPoint4 : Good chemical, oil and water resistance
BulletPoint5 : Material: Pc+Abs. Color: Red
Color : Black on Yellow
ExternallyAssignedProductIdentifier : 7034261803509
ExternallyAssignedProductIdentifier1 : 888434575536
ExternallyAssignedProductIdentifier2 : 0888434575536
IncludedComponents : Pack of 5 Cards
ItemName : Brady 7298-1-PK, Waste Pipe Marker Black on Yellow 1 per Card, 5 PK, Legend 'Waste'
ItemPackageDimensions_Height : 36.1 centimeters
ItemPackageDimensions_Length : 0.7 centimeters
ItemPackageDimensions_Width : 5.9 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : industrial-pipe-markers
Manufacturer : Brady
Material : Vinyl
ModelNumber : 7298-1-PK
NumberOfBoxes : 1
NumberOfItems : 5
PackageLevel : unit
PartNumber : 7298-1-PK
ProductDescription :

Product Description

Product Name: Wide-angle lens
Material: PC mirror surface+ABS
Dimensions: 30cm , 45cm , 60cm , 75cm , 80cm ,100cm
Note: Check the looseness regularly after installation, tighten the screws and nuts (gift accessories)
Scope of application: parking lots, driveways,10 warehouses, supermarkets and other areas with high security risks.
There is a protective film on the surface of the product. Please remove the protective film after the installation is completed.
Safety: doesn't matter if you use it indoor or outdoor. Use it as a garage mirror, parking assistance in parking areas or as a driveway mirror to watch the street at confusing corners.
Used to eliminate blind spots to prevent accidents, injuries and also be used to improve security around or in buildings.

Removing the protective film:
Using a slightly sharp item (like a coin‘s edge) make a tiny opening in the protective film on the edge of the mirror‘s reflective surface, while being careful not to scratch it. Then, pull the protective film and the opening will be larger. Continue pulling the protective film untill the whole reflective surface of the mirror is revealed.
installation steps:
1. Fix the left and right L-shaped fittings to the back of the mirror with bolts, and make sure that the arc-shaped fixing holes of the L-shaped fittings face downward.
2. Drill a mounting hole in the appropriate position of the wall, connect the wall fittings to the wall with expansion screws, adjust the appropriate position and tighten.
3. Finally connect the levers to the wall fittings and the L-shaped fittings, and adjust the angle and position to tighten.

Note
All dimensions are measured manually with
ProductSiteLaunchDate : 2022-05-12T16:12:53.595Z
SupplierDeclaredDgHzRegulation : not_applicable