Cart 2 india

Specification
Brand : UIOTEC
BulletPoint1 : 1. Using the sensitive type photosensitive resistance sensor
BulletPoint2 : 2. The comparator output signal clean waveform is good, driving ability, than 15mA.
BulletPoint3 : 3. With adjustable potentiometer can adjust the brightness of the light detected
BulletPoint4 : 4. Working voltage 3.3V-5V, the output format: Digital switching output (0 and 1)
BulletPoint5 : 5. With bolt holes for easy installation, a small board PCB size: 3.2cm x 1.4cm, using a wide voltage LM393 comparator
ExternallyAssignedProductIdentifier1 : 0799355688246
ExternallyAssignedProductIdentifier2 : 799355688246
ItemName : UIOTEC Digital Light Intensity Detection Photosensitive Sensor Module for Arduino UNO
ItemPackageDimensions_Height : 1.1368 centimeters
ItemPackageDimensions_Length : 4.6457 centimeters
ItemPackageDimensions_Width : 3.3713 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-component-photoelectric-sensors
Manufacturer : UIOTEC
Material : copper
ModelNumber : SG-TL70-Y
NumberOfItems : 1
PartNumber : MPNCA0823B07DPFGPHF
ProductDescription :

Module Features :

1.Can detect the brightness and the ambient light intensity (compared with photo-resistor, this module has better directionality , can sense light in fixed direction)

2.Adjustable sensitivity (use the blue digital potentiometer to adjust)

3.Operating Voltage: 3.3V-5V

4.Output Format : DO digital switching outputs (0 and 1) and AO analog voltage output

5.Has a fixed bolt holes for easy installation

6.PCB Size : 3.2cm * 1.4cm



Module Instructions:

1.Photodiode module is most sensitive to environmental light intensity , generally used for detecting the ambient brightness and light intensity , can be common with photosensitive resistance sensor module in most cases , the difference between this two is that Photodiode module has a better directionality, can sense light in fixed direction;

2. When ambient light intensity does not reach the threshold value, the module DO port output high; when the ambient light intensity exceeds a set threshold, the D0 output low;

3.Digital outputs D0 can be directly connected with the microcontroller through the microcontroller to detect high and low , thereby detecting the light intensity changes in the environment;

4. Analog output and the AD conversion process, can achieve higher accuracy.



Product Wiring Instructions:

VCC ---- "+"

GND ---- "-"

DO ---- TTL Signal Output

AO ---- Analog Signal Output

ProductSiteLaunchDate : 2018-08-23T07:26:50.160Z
UnspscCode : 46171600