Cart 2 india

Specification
Brand : Oumefar
BulletPoint1 : 【Over-speed (EIM Plus only) 】: The EIM Plus monitors the speed from the magnetic pick-up. If the engine speed rises a certain pre-setable value, this engine interface module sends a zero volt to the generator set control panel to activate the over-speed fault circuitry
BulletPoint10 : This item has new two-way large power silicon controlled rectifier and the current can be up to 80A, which is a good solution to over-current of electric stove wire caused by low resistance during cooling
BulletPoint2 : 【Individual Protection】: Our DC 12V engine interface module is a sealed, engine mounted module that provides switching relays for the Starter Motor Solenoid, Glow Plug and Fuel Solenoid. Each of these circuits is protected with individual mounted in the module. Individual LED's illuminate when each circuit is energised
BulletPoint3 : 【EMI Plus】: There are two versions of the engine interface module available: EIM Basic: The EIM is utilised in conjunction with control panels equipped with over-speed shutdown. EIM Plus: The EIM plus is used in conjunction with control panels not equipped with over-speed shutdown
BulletPoint4 : 【Over-speed Set Point】: The over-speed Set Point is factory set at 55 Hz for 50 Hz sets and 66 Hz for 60 Hz sets. This can be adjusted using the adjustment screw accessed through the hole beside the over-speed Set-up LED
BulletPoint5 : 【Adjustable Screw】: While the engine is running at the rated speed (1500 rpm for 50 Hz or 1800rpm for 60 Hz) the adjustment screw should be adjusted until the Over-speed Set-up LED just goes out. This sets the over-speed value at 10% the speed at which the generator set is operating
BulletPoint6 : It can easily adjust the output voltage on a scale of 0-100% (nonlinear) to power electric device
BulletPoint7 : Designed with large and thick heat sink that would enhance heat dissipation
BulletPoint8 : Voltage regulator has voltage absorbing circuit and effective protects large power silicon controlled rectifier, longer service life and more durable
BulletPoint9 : This voltage regulator is adjusted with button which is much more stable than potentiometer
Color : Red
ExternallyAssignedProductIdentifier : 8063481151502
ExternallyAssignedProductIdentifier1 : 712979920097
ExternallyAssignedProductIdentifier2 : 0712979920097
Horsepower : 50 kilowatts
IncludedComponents : DC Motor Driver
ItemName : Oumefar EIM 630-465 DC 12V Engine Interface Module Speed Control Board for Starter Motor Solenoid Glow Plug EIM Plus 630-465
ItemPackageDimensions_Height : 19.3 centimeters
ItemPackageDimensions_Length : 6.3 centimeters
ItemPackageDimensions_Width : 17.6 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : motor-speed-controllers
Manufacturer : Oumefar
Material : Copper
ModelName : Garosam5ygdefoct
ModelNumber : Garosam5ygdefoct
NumberOfItems : 1
PartNumber : Oumefaradkits70nu
ProductDescription : Features:
The Engine Interface Module is a sealed, engine mounted module that provides switching relays for the Starter Motor Solenoid, Glow Plug and Fuel Solenoid. Each of these circuits is protected with individual mounted in the module. Individual LED's illuminate when each circuit is energised. There are two versions of the Engine Interface Module available: EIM Basic: The ElM is utilised in conjunction with control panels equipped with overspeed shutdown. EIM Plus: The ElIM plus is used in conjunction with control panels not equipped with overspeed shutdown. Overspeed (EIM Plus only) The ElM Plus monitors the speed from the magnetic pick-up. If the engine speed rises a certain pre-setable value, the module sends a zero volt to the generator set control panel to activate the Overspeed Fault circuitry. The Overspeed Set Point is factory set at 55 Hz for 50 Hz sets and 66 Hz for 60 Hz sets. This can be adjusted using the adjustment screw accessed through the hole beside the Overspeed Set-up LED. While the engine is running at the rated speed (1500 rpm for 50 Hz or 1800rpm for 60 Hz) the adjustment screw should be adjusted until the Overspeed Set-up LED just goes out. This sets the overspeed value at 10% the speed at which the generator set is operating.
Specification:
Condition: brand new
Item: 630-645
Voltage: 12V DC
Model: EIM PLUS 
Type: 859767

Package List:
1 * Engine Interface Module

ProductSiteLaunchDate : 2020-09-21T07:42:06.308Z
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredDgHzRegulation1 : not_applicable
SupplierDeclaredDgHzRegulation2 : not_applicable
SupplierDeclaredDgHzRegulation3 : not_applicable
SupplierDeclaredDgHzRegulation4 : not_applicable
SupplierDeclaredDgHzRegulation5 : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1
UnspscCode : 39120000
Voltage : 220 volts
Voltage1 : 24 volts
Voltage2 : 18 volts