Specification Brand : Knowtek BulletPoint : Reland Sung BulletPoint1 : This module is supplied as a stepper drive . To control the stepper motor, but also must have the drive to use. BulletPoint2 : The controller has high, medium and low total of three types of frequency can be used to select jumper. BulletPoint3 : Frequency of measurement can amount PUL and common cathode terminal (GND) two ports. BulletPoint4 : PUL + and PUL- pulsed positive and negative; EN + and EN- is to enable the positive and negative terminals; DIR + and DIR- are the positive and negative directions. These six lines are connected to drive the corresponding pulse, direction, so six ports p BulletPoint5 : Power supply: 15-160VDC or 5-12VDC. If you are using 5-12VDC power, positive end connect DC 5-12V Input, negative end connect Common Cathode End. ExternallyAssignedProductIdentifier : 7440129363366 ExternallyAssignedProductIdentifier1 : 0789904559301 ExternallyAssignedProductIdentifier2 : 789904559301 ItemDisplayDimensions_Length : 1.31 inches ItemName : Knowtek ESD5111 Engine Speed Control Unit Governor Controller for Diesel Generator ItemPackageDimensions_Height : 16.6 centimeters ItemPackageDimensions_Length : 6.1 centimeters ItemPackageDimensions_Width : 9.2 centimeters ItemPackageQuantity : 1 ItemTypeKeyword : motor-speed-controllers Manufacturer : KNOWTEK Material : copper MaximumRotationalSpeed : 15 rpm ModelNumber : ESD5111 NumberOfItems : 1 PartNumber : ESD5111 ProductDescription : Specification: Power supply voltage: 15-160V / 5-12V Frequency: High: 5.8KHZ-127KHZ, Mid: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZ Size: Approx. 73 x 51 x 37mm / 2.87 x 2 x 1.45inch Weight: 50g Quantity: 1pc
Package List: 1 x PWM Generator
Note: If you use to start or stop the function, ENA controller enable terminal must be connected to common cathode or common anode drive.