Cart 2 india

Specification
AgeRangeDescription : adult
Brand : PXRZXBICQ
BulletPoint1 : Easy to adjust: makes it high stability, and simple for operation
BulletPoint2 : Voltage stabilizer: Can be used for voltage regulation, speed regulation, temperature regulation
BulletPoint3 : Output control mode: ON/OFF, Constant Voltage, Constant Current, Constant Power, Can be changed as your need.
BulletPoint4 : Wide applications: Household appliances, industrial appliances, factories, schools and other electrical equipment
BulletPoint5 : Protective function: Protection for power supply frequency exceeds, Protection for input voltage failure, Overheating protection, Over current protection, Phase loss protection, Load disconnection protection
Color : One Color
ExternallyAssignedProductIdentifier : 7320488776710
IncludedComponents : No
ItemName : Engine Part MSP6724 MPU Magnetic Pickup Speed Sensor Rotational Sensor
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : motor-speed-controllers
Manufacturer : PXRZXBICQ
ModelName : PXRZXBICQ
ModelNumber : PXRZXBICQ
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : PXRZXBICQ
ProductDescription : Engine Part MSP6724 MPU Magnetic Pickup Speed Sensor Rotational Sensor
Description
*The magnetic speed sensor indicates when ring geat teeth, or other ferrous projections, pass the tip of the sensor.
*Electrical impulses are induced within the coil and sent to the speed control unit.
*The signal from the magnetic speed sensor, teeth per second(HZ), is directly proportional to engine speed.The magnetic speed sensor is mounted in the ring gear case or fly wheel bell housing of the engine.
*The threaded hole for the speed sensor should be perpendicular to the centerline of the crankshaft andcentered over the ring gear teeth.
*A spot face should be present to provide a flast surface on which to anchor the locknut.
*With the engine stopped, screw the speed sensor in until it touches a gear tooth, then back it out 0.75 of aturn and secure it with the locknut.
*Any ferrous gear may be used as long as the frequency and amplitude of the resulting signal meet thespeed control unit specifications.
*The wire leads should be twisted for their entire length from the magnetic speed sensor to the control unit.
*The leads may need shielding if they are longer than 10 ft(3 metres), or if external interferenceis present.
Do not connect either of the speed sensor leads to anything but the speed control unit used.The shield should not be connected at the speed sensor end.

Thread Size : 3/4-16UNF
Off-tooth distance : 028 in min.-.042 in max
MAX output : 30V AC
Length : 102mm
Range : 50-5000Hz
Idle output : 1.5 volts AC Min
ProductSiteLaunchDate : 2024-10-15T03:06:56.263Z
Size : One Size
UnitCount : 1
WarrantyDescription : No warranty.