Cart 2 india

Specification
Brand : YWNYT
BulletPoint1 : Practical: The motor controller board adopts dual H bridge, single 7A current, high power, can drive two DC motors at the same time
BulletPoint10 : This item has new two-way large power silicon controlled rectifier and the current can be up to 80A, which is a good solution to over-current of electric stove wire caused by low resistance during cooling
BulletPoint2 : Under Voltage Protection: Single optocoupler isolation input, the motor driver module is with under voltage protection to prevent instantaneous large current from damaging the module
BulletPoint3 : Double H-bridge: Capable of driving two DC motors simultaneously, single circuit 7A current, high power
BulletPoint4 : PWM Speed Control: Enable signal terminal (ENA) input PWM can regulate speed, PWM frequency range 0-10KHZ
BulletPoint5 : Enhance EMC Performance: The high-power TVS and electrostatic discharge circuit suppress transient interference pulses and static electricity, enhance EMC performance
BulletPoint6 : It can easily adjust the output voltage on a scale of 0-100% (nonlinear) to power electric device
BulletPoint7 : Designed with large and thick heat sink that would enhance heat dissipation
BulletPoint8 : Voltage regulator has voltage absorbing circuit and effective protects large power silicon controlled rectifier, longer service life and more durable
BulletPoint9 : This voltage regulator is adjusted with button which is much more stable than potentiometer
Color : Red
ExternallyAssignedProductIdentifier : 3458519479041
IncludedComponents : DC Motor Driver
ItemName : 3Pcs L298 Dual H Bridge Motor Driver Controller Board Module Stepper DC 6.5V-27V 7A PWM Motor Regulator Board with Optocoupler Isolation
ItemPackageDimensions_Height : 1 inches
ItemPackageDimensions_Length : 2 inches
ItemPackageDimensions_Width : 2 inches
ItemPackageQuantity : 1
ItemTypeKeyword : motor-speed-controllers
Manufacturer : moutainsmart
Material : gold
ModelName : Mrisatavtgp0riu6m
ModelNumber : Mrisatavtgp0riu6m
NumberOfItems : 1
PartNumber : FLY0924
ProductDescription : Product parameters:
Supply voltage 6.5V-27V, the power supply cannot be reversed or exceed 27V, otherwise the module may burn out. It is recommended to connect a fuse in series at the power input end.
Dual-channel motor interface, each rated output current 7A, peak current 50A, the motor interface cannot be short-circuited, it is recommended to connect a 10A fuse in series.
Control signal voltage 3-6.5V, respectively enable signal and forward and reverse control signal.
Enable signal end (ENA) input PWM adjustable speed, PWM frequency range 0-10KHZ, PWM small pulse width 10us.
Working temperature -25℃-80℃
Mounting hole diameter: 3mm, pay attention to the short circuit of the back circuit during installation, you can add an insulating pad or copper column to raise the circuit board.

Suitable motor parameters:
Motors with a rated voltage of 24V are suitable for motors with a rated power of 115W or less or rated current of 7A or less to work at full capacity for a long time
Motors with a rated voltage of 12V are suitable for motors with a rated power of 40W or less or rated current of 7A or less to work at full capacity for a long time
ProductSiteLaunchDate : 2024-09-24T06:00:48.709Z
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredDgHzRegulation1 : not_applicable
SupplierDeclaredDgHzRegulation2 : not_applicable
SupplierDeclaredDgHzRegulation3 : not_applicable
SupplierDeclaredDgHzRegulation4 : not_applicable
SupplierDeclaredDgHzRegulation5 : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1
UnspscCode : 26111500
Voltage : 220 volts