Cart 2 india

Specification
Brand : FTVOGUE
BulletPoint1 : This module is supplied as a stepper drive signal. To control the stepper motor, but also must have the drive to use.
BulletPoint2 : The controller has high, medium and low total of three types of frequency signals can be used to select jumper.
BulletPoint3 : Frequency of measurement can amount PUL and common cathode terminal (GND) two ports.
BulletPoint4 : PUL + and PUL‑ pulsed positive and negative; EN + and EN‑ is to enable the positive and negative terminals; DIR + and DIR‑ are the positive and negative directions. These six lines are connected to drive the corresponding pulse, direction, so six ports p
BulletPoint5 : Power supply: 15‑160VDC or 5‑12VDC. If you are using 5‑12VDC power, positive end connect DC 5‑12V Input, negative end connect Common Cathode End.
Color : #563
ExternallyAssignedProductIdentifier : 7629465504347
FinishType : 33
HoleCount : 1
IncludedComponents : No
ItemName : 2PCS Stepper Motor Controller PWM Pulse Signal Generator Speed Regulator Board
ItemPackageDimensions_Height : 6 centimeters
ItemPackageDimensions_Length : 12 centimeters
ItemPackageDimensions_Width : 8 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : motor-speed-controllers
Manufacturer : FTVOGUE
Material : Plastic
ModelName : FTVOGUEvognqkzuiy
ModelNumber : FTVOGUEvognqkzuiy
MountingType : Embedded
NumberOfHandles : 1
PartNumber : FTVOGUEvognqkzuiy
ProductDescription : Specification:
Frequency: High: 5.8KHZ-127KHZ, Mid: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZ
Size: Approx. 50 x 51 x 37mm / 1.97 x 2 x 1.45inch
Weight: 50g
Quantity: 1pc
Package List:
1 x PWM Generator
Note:
1.If you use to start or stop the function, ENA controller enable terminal must be connected to common cathode or common anode drive.
2. Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering
ProductSiteLaunchDate : 2024-11-07T09:15:52.053Z
RecommendedUsesForProduct : Indoor/Outdoor
UnitCount : 1
UnspscCode : 30181700