Cart 2 india

Specification
Brand : Jolooyo
BulletPoint : Drives
BulletPoint1 : Module nature: H-bridge brushless DC motor drive module, suitable for high-power DC motors of 3-36V
Scope of application: High power DC motor drive. In situations where wide input voltage (11-36V) is required, such as various controls for large cars, robots, etc.

BulletPoint2 : Drive voltage: DC 11-36V Input DC voltage (AC input prohibited)
Output current: 15A below 360W at rated continuous output 24V, no heat sink required, maximum 36V 15A 450W
BulletPoint3 : Output power: Natural cooling rated 450W, measured at 36V 15A power supply
Working temperature: Industrial grade (-40 ℃ to+85 ℃) Full load temperature: 45 ℃
Weight: 293g

BulletPoint4 : Small size, only 6.6cm x 3.8cm, with a total height of 2.8cm after applying 1cm thick heat dissipation
Supports voltage range of 10-36V, undervoltage protection, independent power supply, up to 50V
Zui has a high continuous load current of 20A (with a simple heat sink attached) and a short-term peak current of 110A

BulletPoint5 : Three line control for speed regulation, forward and reverse rotation, and braking
Supports full PWM, can directly use buttons to control forward and reverse, PWM effective range 0%~100.0%
It can be directly matched with PLC and 3.3V 5V microcontroller IO ports to directly control the built-in interface level buffering function, without worrying about damaging the microcontroller IO.

Color : One Color
ExternallyAssignedProductIdentifier1 : 9177853889210
ExternallyAssignedProductIdentifier2 : 9177853884123
ExternallyAssignedProductIdentifier3 : 9177853881368
ItemName : 450W High-power DC Motor Drive Board Module Controller Capable of Full PWM Forward and Reverse Braking 12V 24V 36V
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-component-motor-drives
Manufacturer : Jolooyo
Material : lithium
ModelNumber : JYSNSY
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : tuoluo603
ProductDescription : This driver board can not only simulate control, but also directly accept microcontroller IO drive! This system not only simulates control, but also has good protection functions.
(1) Using imported full bridge drive chips and low-pass internal resistance 110A NMOS drive tubes, it is easy to achieve motor braking and forward and reverse rotation.
(2) The chip operates at a frequency of up to 600KHz, which effectively solves the problems of high motor noise and heat generation caused by MC33886 and VNH3SP30. At the same time, the driving ability has been significantly improved, and the response speed is fast. The performance of this driver is not comparable to motor drive chips such as L298, IR2104, MC33887, etc
(3) Two PWM inputs, with a duty cycle of 0-100%, are not achievable by typical drivers. Has instant braking ability and helps you easily achieve precise speed control throughout the entire journey.
(4) It has the ability to adapt to a wider working voltage of 10.5-36V, suitable for robots or car model competitions directly powered by lithium batteries.
(5) Built in logic buffer isolation circuit. Supports direct control of PLC and various types of 3V or 5V microcontroller IO ports, and can also control motor braking and forward and reverse rotation through analog voltage input.
(6) The control is simple, convenient, and easy to use. Only 3 input wires are needed to control the motor braking and forward and reverse rotation.
(7) The chip is equipped with hardware control for dead time, which can effectively protect the H-bridge and avoid direct damage when the motor frequently changes direction, making software programming simpler.
(8) The chip operates at a frequency of up to 600KHZ, suitable for driving hollow pocket motors, with low noise and low heat generation.

ProductSiteLaunchDate : 2024-07-09T03:36:17.037Z
Size : 36-50W X 2
UnitCount : 1
UnspscCode : 32131000