Cart 2 india

Specification
AgeRangeDescription : Adult
Brand : Teton Foundry Supply
BulletPoint1 : High-Strength Gypsum-Based casting material
BulletPoint2 : 6000 PSI strength when dry: resistant to breaking and chipping
BulletPoint3 : Very Fine-Grain: High-Detail Capture Possible
BulletPoint4 : Can be Carved or Added to After Drying
BulletPoint5 : Easy to Use: Mix By Weight, not Volume
Color : White
CustomerPackageType : Standard Packaging
ExternallyAssignedProductIdentifier1 : 650728246824
ExternallyAssignedProductIdentifier2 : 0650728246824
GpsrSafetyAttestation : 1
ItemName : Hydrocal White High-Strength Gypsum Molding Casting Material (10lb)
ItemPackageDimensions_Height : 29 centimeters
ItemPackageDimensions_Length : 7.3 centimeters
ItemPackageDimensions_Width : 25 centimeters
ItemPackageQuantity : 1
ItemShape : Round
ItemTypeKeyword : molding-and-casting-materials
Manufacturer : Teton Foundry Supply
Material : Gypsum
ModelName : Silicone Mold
ModelNumber : KRQE5529115ZT9LVHVZ
NumberOfItems : 1
NumberOfPieces : 2
PartNumber : HYDROWHITE
ProductDescription :

Overview
Teton Foundry Supply™ prepackaged Hydrocal®* White is a high-performance gypsum-based casting material that reaches an impressive 6000 psi strength when fully cured. Use it where fine-detail reproduction is desired along with chip-resistance.

Supported Applications
-Solid/Hollow casting of various decorative objects
-Low-use foundry patterns and other similar tooling Uses
-Modeling (scenery) and professional art applications
-This product is NOT compatbile with molten metal (do not use as a mold for molten metal)
-This product is NOT recommended for outdoor or wet area use.
-DO NOT use this product to make castings of humans or live animals (severe burns possible).

Directions
-Mix 40 to 41 parts water per 100 parts Hydrocal (by weight)
-Always add plaster to water, sift or break apart lumps in plaster before adding, and mix well.
-Sets approximately 25-35 minutes after mixing
-Clean tools prior to product setting or it may be hard to remove product from tools.

Application Notes
-Product may be carved and/or added to after curing (does not unduly dull tools)
-Appropriate mold release should be used with all patterns to avoid sticking.
-Generally, bubbles should be removed from the pattern surface to avoid visible defects in the casting (a damp paint brush under the surface of the wet plaster works for smaller items)
-Voids from bubbles or other flaws may be patched with a small amount of new plaster as needed.

Product Size/Volume/Weight Info
-10lb of this product makes approximately 225 cubic inches of cast material (similar volume to a cube measuring 6"X6"X6")
-Wet density is 110lb/cubic ft
-Dry density is 90lb/cubic ft

*=Hydrocal® is a registered trademark of USG corp.
ProductSiteLaunchDate : 2018-09-12T07:00:00.000Z
RecommendedUsesForProduct : Modeling
Size : 10lb
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 60124500
WarrantyDescription : no