Cart 2 india

Specification
Artist : Artist
Brand : WAAZVXS
BulletPoint1 : Model Number: GDZ-17
BulletPoint2 : Type: 1.5kw woodworking water-cooled spindle
BulletPoint3 : Drive: MOTOR
BulletPoint4 : Operating Speed: 40000rpm
BulletPoint5 : Application: Milling
Color : 380V
ExternallyAssignedProductIdentifier : 7557791680988
FinishType : Finish
Horsepower : 1.5 kilowatts
IncludedComponents : inc
ItemName : WAAZVXS 1.5KW GDZ-17 CNC Spindle Water Cooled Motor Φ80mm 40000rpm ER11 Chuck CNC Milling Machine Wood Carving 220V/380V (Color : 380V, Size : 80x180mm)
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : power-milling-machines
Manufacturer : WEIWEIBEIER
Material : Metal
MediaType : ArtworkMedium
ModelName : WWBR
ModelNumber : WWBR
NumberOfItems : 1
PartNumber : WWBR
PowerSourceType : PowerSource
ProductDescription : The working environment temperature of the spindle is usually -1040. Before installing the first electric spindle to rotate the spindle head by hand, you should feel flexibility and no blockage.P4 fully sealed angular contact ball 7 series bearings can extend the life of the spindle. The longer length makes the torque bigger and the power bigger. Accuracy 0.01mm, coaxial cable degree less than 0.0025mmWhen the spindle is stored and transported, the bearing condition inside the high-speed grease will change, and the customer should run it at low speed for 30 minutes. Then increase slowly at a speed of 3000 rpm, running for 20 minutes each time. The spindle and inverter should work together.The specifications and parameter of the inverter match the spindle parameters. To connect the inverter main shaft, the three-phase inverter power cord should be welded to the plug 1 (U), 2 (V), 3 (W) pin, and the grounded pin 4. After turning on the power, observe whether the spindle rotation axis always shows the direction.If it is inconsistent, turn it off immediately, and replace the two wires of the three-phase power supply connected to the inverter and the spindle.Before using the spindle every day, it must run at low speed for 15-20 minutes. Clamp the cutter on the spindle, the chuck nut, chuck, and cutter must be clean enough. The shank inserted into the chuck must be larger than 15mm.The water-cooled spindle must be used together with the water pump. Otherwise, the spindle will quickly break. The AC spindle motor must be used together with the inverter. The power of the inverter needs to be equal to or greater than the power of the spindle. Before use, please set the inverter parameters suitable for the spindle. Otherwise, the spindle and inverter will break immediately. When using the spindle, the noise is different from before, so please stop the spindle immediately. You need to replace the spindle bearing.The spindle fre
ProductSiteLaunchDate : 2024-04-24T06:50:33.857Z
Size : 80x180mm
Speed : 40000 rpm
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
TheatricalReleaseDate : 2024-04-24T12:17:45.000-07:00
UnitCount : 1
Voltage : 380 volts