Cart 2 india

Specification
Brand : MTQY
BulletPoint1 : Package includes:2pcs M8 float switch. Material:plastic.
BulletPoint2 : Float level switch is a simple structure, easy to use level control device.
BulletPoint3 : Long life, good reliability, high pressure resistance, good stability in water.
BulletPoint4 : Mainly used for sensing the liquid level in the tank, switching on/off the pump, indicator light, liquid level alarm, etc.
BulletPoint5 : Suitable for hydroponics, gardening, aquarium power control, fish tanks, filtration and more.
Color : Silver
ExternallyAssignedProductIdentifier : 6131402018431
IncludedComponents : No
ItemName : MTQY 2PCS M8 Plastic Float Switch Vertical Liquid Level Sensor for Aquarium Fish Tank DIY Measuring Tool
ItemPackageDimensions_Height : 1.2 centimeters
ItemPackageDimensions_Length : 12 centimeters
ItemPackageDimensions_Width : 8 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-component-liquid-level-sensors
Manufacturer : MTQY
ModelName : Kavolet3hb6wsv5zi
ModelNumber : Kavolet3hb6wsv5zi
NumberOfItems : 1
PartNumber : 36488-PFSVL-2
ProductDescription : Maximum contact rating: 10W
Maximum switching current: 0.5A

One or more reed tubes are set in closed metal, then the tubes are passed through one or more hollow balls with hollow magnets inside, and the floats within the relevant range of the reed switch are held in place by a retaining ring. Internally, when the float moves, the magnet inside it attracts the reed switch contacts to act as a level control or indication.

Installation:
1.the mounting position should be away from the water inlet, otherwise the switch will cause malfunction due to fluctuation of the water inlet.
2.If the switch device is on the container wall, add l angle bracket.
3.Select a flange connection pipe with an inner diameter larger than the float diameter.
4.multi core cable is recommended for wiring.
5.the control line load must be matched to the float switch contact capacity.
6.The specific gravity of the measured liquid must be greater than the specific gravity of the float.



Contact protection circuit:
When the float switch is applied to a circuit with inductive loads such as motors, relays, solenoid coils, etc., it is recommended that protection circuits such as RC (snubber), varistors, diodes, etc. be connected to both ends of the load.

Note: Do not connect the float switch directly to a solenoid valve, motor or solenoid switch.

When the float switch is used for capacitive loads (e.g. capacitors, light bulbs, long cables, etc.), an expansion current will be generated between its contacts, and it is recommended that the protection circuits at both ends of the float switch be connected in parallel.
ProductSiteLaunchDate : 2024-10-29T07:18:37.395Z
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 14.674
UnspscCode : 46171600