Cart 2 india

Specification
Brand : Furick Cup
BulletPoint1 : Occupational Health & Safety
BulletPoint2 : Country of Manifacturer: United States
BulletPoint3 : Manufacturer: Miller Electric
BulletPoint4 : Included components: Unit
BulletPoint5 : Instruction Guide
ExternallyAssignedProductIdentifier1 : 0810036840064
ExternallyAssignedProductIdentifier2 : 810036840064
ExternallyAssignedProductIdentifier3 : 0716352004626
ExternallyAssignedProductIdentifier4 : 0716352153454
IncludedComponents : Unit^Instruction Guide
ItemName : Furick Cup FUPA #12 Welding Cup Kit w/Titanium Protector (2 Cups, 1 Cover, 4 O-Rings, 1 Spare Diffuser)
ItemPackageDimensions_Height : 30.48 centimeters
ItemPackageDimensions_Length : 65.786 centimeters
ItemPackageDimensions_Width : 39.116 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : gas-welding-kits
Manufacturer : Furick Cup
ModelNumber : 0790-0105
NumberOfBoxes : 1
NumberOfItems : 1
PackageLevel : unit
PartNumber : FU12KC
ProductDescription : Note: This cup requires the use of a large diameter gas lens (45V44) to fit #9 & #20 torches or the Furick Torch Mount Kit to fit #17, #18 and #26 torches. If you have one already you can surely use it, but keep in mind that import brands tend to yield lower results.

The Furick Cup FUPA #12 w/ Cover Kit comes with two cups, three spare o-rings, one spare diffuser, and one titanium protective cover. The included titanium cover slips over the end of the cups to add a layer of protection against accidental bumps. The Furick FUPA #12 covered glass covered welding cup uses anywhere from 25-30+ CFH of argon flow depending on the application. It is recommended for use with 3/32" tungsten and carries a 180 amp rating on constant amperage, which can be increased if using pulse settings. The FUPA Cup carries Furick's patented double diffuser design for optimum gas coverage.

All Furick Weld Cups are hand made in the USA from laboratory grade borosilicate glass. Due to the nature of the glass, "walking the cup" is not recommended with the glass Furick Cups. The FUPA 12 is recommended for mild steel, stainless steel, chromoly, titanium, inconel and other space grade alloys. It works best on thinner/smaller applications such as header tubes and chassis tubing.

It is recommended with all the BIG Diffuser Cups that you start off on low amp settings to stabilize the arc, making sure you will not arc off the diffuser. If diffuser arcing occurs you will have to clean/regrind the tungsten. You will not hurt the diffuser on low amps but if you arc with high amps you can deteriorate the diffuser. Also be careful not to drop or hit cups against hard objects, as we all know the fragile nature of glass!
ProductSiteLaunchDate : 2020-02-20T17:06:21.480Z
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1