Cart 2 india

Specification
Brand : DripWorks
BulletPoint1 : This 1/4" polyethylene tubing has small emitters pre-installed every 12 inches
BulletPoint2 : Flexible and can be wound through flower beds or borders, around trees or shrubs, run down rows or raised vegetable beds and can be used in container planting
BulletPoint3 : Inexpensive and effective method for watering a variety of plants and gardens
BulletPoint4 : Works well with gravity and low pressure systems
BulletPoint5 : 500-foot roll of tubing, 1 roll
Color : Black
ExternallyAssignedProductIdentifier1 : 0689728652205
ExternallyAssignedProductIdentifier2 : 689728652205
IncludedComponents : hose
ItemName : Soaker Dripline 12" Spacing 500' Roll
ItemPackageDimensions_Height : 2 inches
ItemPackageDimensions_Length : 9.51 inches
ItemPackageDimensions_Width : 9.5 inches
ItemPackageQuantity : 1
ItemTypeKeyword : automatic-lawn-irrigation-tubing
ItemTypeName : hose
Manufacturer : Dripworks
Material : Polyethylene (PE)
MaximumPressure : 20 pounds_per_square_inch
ModelName : 18feet
ModelNumber : 8mm hose 4mi
NominalWallThickness : 0.25 inch
NumberOfItems : 1
PartNumber : ED12BL/500
ProductDescription :

This 1/4" polyethylene tubing has small emitters pre-installed every 12". It is flexible and can be wound through flower beds or borders, around trees or shrubs, run down rows or raised vegetable beds and can be used in container planting. It is an inexpensive and effective method for watering a variety of plants and gardens. Soaker Dripline also works well with gravity and low pressure systems.

Flow rate is measured in gallons per hour (GPH) and varies with pressure

• Flow rate at 10 PSI is approximately 42 GPH per 100' roll (0.42 GPH per emitter)
• Flow rate at 20 PSI is approximately 60 GPH per 100' roll (0.60 GPH per emitter)
• Flow rate at 30 PSI is approximately 80 GPH per 100' roll (0.80 GPH per emitter)

Maximum recommended run length for a row of 12" spaced Soaker Dripline is 34 feet

How to use Soaker Dripline:

• Use a to make a 1/4" hole in the where each line of Soaker Dripline will connect.
• Insert a 1/4" or into the beginning of each line of Soaker Dripline, then connect to the mainline tubing.
• Place the Soaker Dripline around your plants, being careful not to exceed the maximum run length for a single line.
• Use a to seal off the end of each line of Soaker Dripline.
• Use or wire hold downs to pin the Soaker Dripline in place.
• The can be used to easily insert tranfer barbs and goof plugs into Soaker Dripline.

ProductSiteLaunchDate : 2018-03-24T07:00:00.000Z
Size : 12 Inch
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1