Cart 2 india

Specification
Brand : Drip Depot
BulletPoint1 : Extra flexible and kink resistant tubing means tighter turns with fewer elbows for easier installation
BulletPoint2 : Dual-layered tubing (brown over black)
BulletPoint3 : Colored stripes on the tube designate flow rate tan = 0.6gph
BulletPoint4 : Laser etched information on the tube allows easy identification of dripline type, flow rate and spacing
BulletPoint5 : XFDe-9-12-250: XFDe, 0.9 gph(3.5I/h), 12"(30.5cm) spacing, 250'(76.2m)
Color : Black
ExternallyAssignedProductIdentifier : 20077985085791
ExternallyAssignedProductIdentifier1 : 0818564012380
ExternallyAssignedProductIdentifier2 : 818564012380
ItemName : 1/2" Polyethylene Pressure Compensating Drip Line - Emitter Spacing : 9" - Flow Rate : 1.0 GPH - Roll Length : 100'
ItemPackageDimensions_Height : 1 inches
ItemPackageDimensions_Length : 7.5 inches
ItemPackageDimensions_Width : 1.01 inches
ItemPackageQuantity : 1
ItemTypeKeyword : automatic-lawn-irrigation-tubing
ItemTypeName : Dripline
Manufacturer : Drip Depot
MaximumPressure : 50 pounds_per_square_inch
ModelName : XFDeDripline-09-12-250
ModelNumber : XFDe912250
NumberOfItems : 1
PartNumber : PC-F6007001009-100DD
ProductDescription : This dripline is a 1/2" (.600" ID X .700" OD) black polyethylene, pressure compensating drip line with pre-installed, in-line drip emitters that provide high uniformity and even distribution of water over longer lengths and uneven terrain. May be hung on a wire, laid on the ground or buried, making it an economical choice for vineyards, orchards, and row crops. As with our blank poly tubing, additional PC emitters and/or 1/4" micro line can be added to this drip line. When adding additional drippers, do not punch too close to the pre-installed emitters and take care not to exceed the maximum flow rate for the specifications and run length.Very effective method to irrigate crops in difficult topographical conditions, low and varying water pressures and where longer laterals are required. This drip line is compatible with our 1/2" Perma-Loc fittings. Do to the tightness the tubing must be rolled it often has a more oval shape when first opening a new roll. There also may be some slight kinking in the center of the roll and where the banding is, this will not hinder the use and performance of the tubing. These issues will smooth out after un-banding and some sun exposure and the ovalness will round out over time or with a few uses (pressurization/depressurization).Features: Built-in filtration prevents particles, which may clog the emitter due to size, from entering emitter ; Large turbulent flow path allows particles to pass freely ; Consistent discharge over a pressure range of 12 - 50 PSI ; CV (coefficient of variation) values less than 5% ; Manufactured from the highest quality materials: polyethylene body and silicon diaphragm; High standards of quality control; Non-CNL;
ProductSiteLaunchDate : 2024-03-08T15:35:24.797Z
Style : Emitter Spacing 9"
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1