Cart 2 india

Specification
Brand : CONFAST
BulletPoint1 : Great for many light-duty uses - Install doorbells, curtain rods, pictures, light mirrors, photo frames, lights in drywall, plaster board, gypsum board, brick wall, concrete wall or wood wall
BulletPoint2 : Easy to Install - use included bit to drill hole, insert the anchor, and place the item against the wall over the anchor, then drive the screw through the hole in to the anchor
BulletPoint3 : Designed to prevent problems during installation - ribs prevent anchor from spinning in the hole while tightening the screw
BulletPoint4 : Plast Anchor material protects against rust and corrosion
BulletPoint5 : Contains ( 1 ) drill bit, ( 100 ) #14-#16 plastic, ribbed anchors, ( 100 ) #10 Phillips head screws
Color : Blue
CompatibleGrooveDiameter : 8.5 millimeters
ExteriorFinish : Steel
ExternallyAssignedProductIdentifier1 : 0820274003411
ExternallyAssignedProductIdentifier2 : 820274003411
ExternallyAssignedProductIdentifier3 : 0014973264901
ExternallyAssignedProductIdentifier4 : 0738287120219
ExternallyAssignedProductIdentifier5 : 00738287120219
ExternallyAssignedProductIdentifier6 : 00014973264901
FinishType : Zinc
GpsrSafetyAttestation : 1
GradeRating : Grade 2
ItemName : CONFAST® #14-16 Plastic Conical Blue Bantam Drywall Wall Anchor Kit PAK1416, Includes (100) Anchors, (100) Screws and (1) Drill bit (201 Pieces)
ItemPackageDimensions_Height : 1.5 inches
ItemPackageDimensions_Length : 7 inches
ItemPackageDimensions_Width : 3.75 inches
ItemPackageQuantity : 1
ItemShape : Conical
ItemTypeKeyword : hollow-wall-anchors
Manufacturer : CONFAST
Material : Plastic
MeasurementSystem : Imperial
MetalType1 : Zinc
MetalType2 : Carbon Steel
ModelNumber : 014973264901
NumberOfItems : 18
NumberOfPieces : 101
PartNumber : PAK1012
ProductDescription : The bantam plastic anchor is intended for light duty, non-critical applications. It can be used with a variety of foundation materials, including concrete, block, and brick. Although it is possible to use in wallboard, the holding values may vary and be unpredictable depending on the application. These anchors should not be used in overhead applications or in situations where holding values are crucial.
Kit includes：
(100) #14-16 anchors
(100) #14 x 1" Screws
(1) carbide drill bit

Installation Instructions:
Using the provided drill bit, make a hole in the base to a depth of at least 1/4" deeper than the required embedment.
Clean the hole of dust and other material, blowing away as much as possible.
Tap the anchor into the hole so it is flush with the base material surface.
Position the fixture and insert the screw through the fixture to the top of the anchor and tighten.
Check that the screw thread fully catches the anchor body and that the anchor does not spin.

ProductSiteLaunchDate : 2022-03-29T15:47:44.116Z
Size : #14 #16
Style : M6*32
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 40
UnspscCode : 31161500