Cart 2 india

Specification
Brand : XT
BulletPoint1 : Rubber Hood Catch Flexible can be used to secure toolboxes, coolers, golf carts or construction equipment, providing a reliable fastening solution to ensure your tools are properly protected
BulletPoint2 : T-Handle Hasp Rubber Flexible contains good elastomeric to deal with vibration-absorbing as well as keeping the flexible preload of the joints
BulletPoint3 : Easy to install: Clean the surface where the T-Handle will be installed Place the T-Handle in the desired location. Make sure it is properly aligned and can be secured with screws, bolts, or other fasteners
BulletPoint4 : TEST the flexible rubber latches with the brackets: After installing the buckle, test it to ensure that it is secure and functioning properly. Open and close the buckle several times to check for looseness or misalignment
BulletPoint5 : UV Resistant, Self-aligning, Non-Corrosive, Non-Conductive
Color : Black
GpsrSafetyAttestation : 1
IncludedComponents : Rubber flexible latches with brackets
ItemName : Rubber Flexible T-Handle Hasp Draw Latch, for Tool Box Cooler (Black) Set of 2
ItemPackageDimensions_Height : 18.1102 centimeters
ItemPackageDimensions_Length : 2.8956 centimeters
ItemPackageDimensions_Width : 12.2936 centimeters
ItemTypeKeyword : hardware-hasps
Manufacturer : XT
Material : Iron
ModelName : Rubber Hood Catch Flexible
ModelNumber : T-handle - 02
NumberOfBoxes : 1
NumberOfItems : 2
PartNumber : T-handle - 02
ProductDescription : T handle draw latch are very versatile and can be used in several ways. For toolboxes: 1.Fully open the toolbox lid. 2.Position the T-shaped rubber buckle on one side of the box, usually near the edge where the lid meets the body. Make sure it is properly aligned so that the buckle securely engages when closed. 3.If the buckle requires screws or bolts for installation, use the appropriate tools to attach it securely to the case. Be sure to tighten the screws sufficiently to prevent the buckle from loosening over time. 4.When closing the toolbox, insert the T-shaped part of the buckle into the corresponding slot or receptacle on the other side of the box. Press firmly to ensure a tight fit. 5.To open the toolbox, simply pull the T-shaped piece out of the slot. This will release the latch and allow you to access the contents of the toolbox.
ProductSiteLaunchDate : 2024-09-27T13:15:28.384Z
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnspscCode : 24101600