Cart 2 india

Specification
Brand : FEIYING
BulletPoint : 10 Pcs 49E Hall Effect Sensor Switch Hall Element SOT23 SS49E AH49E High Sensitivity
BulletPoint1 : Packing list? 2pcs Hall Sensor
BulletPoint2 : Re-move the motor housing screws and open the motor;
BulletPoint3 : Re-move the old Hall and insert the new Hall into the original card slot. Be careful during installation. Do not use excessive force, and then fix it with glue or tape; (Note: do not apply glue to the front of Hall)
BulletPoint4 : Wiring: red and black (positive and negative wires) shall be connected according to color, and yellow, green and blue wires shall be connected at will; (Warm prompt: the yellow green blue lines are connected in the original order, which can avoid multiple wire adjustment and phase change)
BulletPoint5 : When installing the motor cover, it is better to apply sealant to make it, which can effectively reduce the short circuit caused by water ingress into the motor
Color : as shown
ExternallyAssignedProductIdentifier : 4713227139700
ExternallyAssignedProductIdentifier1 : 744915193852
ExternallyAssignedProductIdentifier2 : 0744915193852
IncludedComponents : 1
ItemName : FEIYING Hall Sensor 2Pcs 120 Degree Sensor Guide E Bike Wire Circuit Board
ItemPackageDimensions_Height : 31.4 centimeters
ItemPackageDimensions_Length : 0.6 centimeters
ItemPackageDimensions_Width : 18.4 centimeters
ItemPackageQuantity : 1
ItemShape : Cable Side
ItemTypeKeyword : electronic-component-hall-effect-sensors
Manufacturer : FEIYING
Material : Steel
ModelNumber : HAS50-S
MountingType : Flange Mount
NumberOfItems : 1
PartNumber : FEBA2J18-2/6REDZ
Pattern : HAS200-S
ProductDescription :

Motor Hall installation instructions:

1. Re-move the motor housing screws and open the motor;

2. Pull out the middle steel ring;

3. Re-move the old Hall and insert the new Hall into the original card slot. Be careful during installation. Do not use excessive force, and then fix it with glue or tape; (Note: do not apply glue to the front of Hall)

4. Wiring: red and black (positive and negative wires) shall be connected according to color, and yellow, green and blue wires shall be connected at will; (Warm prompt: the yellow green blue lines are connected in the original order, which can avoid multiple wire adjustment and phase change)

5. When installing the motor cover, it is better to apply sealant to make it, which can effectively reduce the short circuit caused by water ingress into the motor.

Packing list?

2pcs Hall Sensor

ProductSiteLaunchDate : 2024-01-15T06:59:52.751Z
Size : 0-5V output 180 °
Style : 5V supply voltage
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredDgHzRegulation1 : not_applicable
SupplierDeclaredDgHzRegulation2 : not_applicable
SupplierDeclaredDgHzRegulation3 : not_applicable
SupplierDeclaredDgHzRegulation4 : not_applicable
SupplierDeclaredDgHzRegulation5 : not_applicable
UnitCount : 1
UnspscCode : 32120000